Filter
Top Products
21
PREPARATION
En
Display
All the display information is explained and/or referenced here.
Displays & Controls
DIGITAL
dB
PRO LOGIC
STEREO
DSP
MIDNIGHTLOUDNESSATTSIGNAL
SELECT
OVER
H.P
AC-3DTS MPEG
ANALOG
SP AB
L
C
R
LFE
LS S RS
DIGITAL
AC-3RF
AUTO
MPEG
TAPE 2
VOLUME
2
1
4
3
5
6
789
10
11
12
13
14
5 LOUDNESS indicator (See p.49)
Lights when the LOUDNESS mode is on.
6 H.P (headphones)
Lights when headphones are connected to the
PHONES jack (speakers systems A and B both
turn off automatically).
7 MIDNIGHT indicator (See p.48)
Lights when the MIDNIGHT LISTENING mode
is on.
8 DSP indicator (See p.43-45)
Light when a DSP or Advanced Theater modes
are selected.
9 STEREO indicator
Lights when a STEREO mode is selected.
10 Function indicator
Displays the function.
11 2/dts/MPEG mode indicators
2 DIGITAL : When the 2/dts mode on the
amplifier is on, this indicator lights to indicate
playback of a Dolby Digital signal. However,
2
PRO LOGIC lights during 2 channel playback of
Dolby Digital.
2 PRO LOGIC : When the 2/dts mode on the
amplifier is on, this indicator lights during 2
channel playback. ( Both B or A+B speaker
systems turn off automatically when headphones
are plugged.)
DTS : Lights when DTS signals are input.
THX: Lights when the HOME THX CINEMA mode
is selected.
MPEG: Lights when MPEG signals are input.
12
MASTER VOLUME indication
Displays current volume level.
13
TAPE 2 indicator
Lights when the TAPE 2 monitor is on.
14
Character display
Displays sound modes, general information,
1 SIGNAL SELECT indicators
Light to indicate the input signal you selected
of the source signal.
ANALOG : Lights when analog signals are
assigned.
DIGITAL : Lights when digital audio signals are
selected.
AC-3 RF : Lights when AC-3 RF signals are
assigned.
AUTO : Lights when the receiver is set to select
the input signal automatically.
2 Program Format indicators
AC-3 : Lights when a source with Dolby Digital
signals is played.
DTS : Lights when a source with DTS audio
signals is played.
MPEG: Blinks when the MPEG mode is selected,
and lights when a source with MPEG audio signals
is played.
For Dolby Digital or DTS sources, these
indicators change according to which channels
are active in the source. When all three LS (left
surround), S (surround) and RS (right surround)
light at the same time it means a Source with
Surround EX or DTS-ES flag is being used.
L – Left front channel.
C – Center channel.
R – Right front channel.
LS – Left surround channel.
S – Surround channel (mono).
RS – Right surround channel.
LFE – Low Frequency Effects channel.
3 Analog level indicators
OVER – When the source signal is analog, this
lights if the signal is in danger of distorting.
Press INPUT ATT on the remote control to
lower the signal level.
ATT – Lights when INPUT ATT is used to
reduce the level of the analog source signal.
4 Speaker indicators
Light to indicate the current speaker system, A
and/or B.