Filter
Top Products
OPERATION
OPERATION
51
En
Adjusting the Brightness of the Display
Use the FL DIMMER button to adjust the brightness of the fluorescent display (FL=fluorescent display).
Use the FL DIMMER button on the
remote control's Amplifier SUB
screen or the front panel to
alternate between the different
levels of brightness.
Four levels of brightness ranging from very dim to
very bright can be selected. Each press changes the
brightness of the display. When cycling through the
options, the default brightness can also be selected.
Please note: It is a feature of this unit that the
fluorescent display will be brighter for a few
seconds after you choose a function (like DVD/
LD, CD, etc.) and then get softer. This will still
happen when you adjust the brightness but the
new setting will be the one the display softens to.
memo
Basic Playback
Direct Playback
Use the STEREO button on the
remote control or the STEREO/
DIRECT button on the front panel to
alternate between STEREO and
DIRECT mode.
The DIRECT mode will give you the most accurate
reproduction of two channel (stereo) sources but
won't let you add any effects to the sound.
dB
STEREO
SIGNAL
SELECT
ANALOG
SP
A
VOLUME
• None of the tone controls or other sound modes
can be used with DIRECT playback.
• If the amplifier is in a different mode than
STEREO to start with the first push of the
STEREO button will put it in STEREO mode.
After that the button will toggle the amplifier
between STEREO and DIRECT mode.
• Relatedly, see the explanation of the TONE but-
ton on p.23 and the STEREO mode on p.43.
memo
Amplifier
MAIN SUB
DSP STEREO
THX
ADVANCED
THEATER
EFFECT
STANDARD
MIDNIGHT
LOUDNESS
MULTI CH
IN
SIGNAL
SELECT
DIGITAL
NR
/ dts / MPEG
STEREO
STEREO/DIRECT
FL DIMMER
CH
SELECT
TONE
SPEAKER
A/B
Amplifier
MAIN SUB
TREBLE
SYSTEM
SETUP
CH
LEVEL
INPUT
ATT.
BASS
FL
DIMMER
TAPE 2
MONITOR
FL DIMMER
MAIN
SUB