Filter
Top Products
40
En
DUAL MONO SETTING
The dual mono setting can only be used when listening to Dolby Digital discs that have dual mono software
encoded in them. Dual mono software usually is used to put two different soundtracks on one DVD. With this
setting you can choose which channel in the dual mono setting you want to listen to. Thus, it is useful for
soundtracks that have one language on one channel and a different language on the other. Remember this
setting is only applicable if you are using Dolbly Digital software with dual mono and want to isolate one of the
channels therein. Otherwise, just ignore this function.
1
Put the amplifier in STANDBY
mode.
2
While holding down the VIDEO
SELECT button press the
STANDBY/ON button on the
front panel.
3
You will see DUAL in the display for
about five seconds. During this
time use the STEREO/DIRECT
button to cycle through the
different DUAL MONO settings to
find the one you want.
The different settings are: DUAL ch1, where you only
hear channel 1; DUAL ch2, where you only hear
channel 2; and DUAL ch1/ch2, where you hear both
channels, but independently from different speakers.
The default setting is DUAL ch1.
dB
STEREO
SIGNAL
SELECT
ANALOG
SP
A
VOLUME
DUAL ch1 setting
dB
STEREO
SIGNAL
SELECT
ANALOG
SP
A
VOLUME
dB
STEREO
SIGNAL
SELECT
ANALOG
SP
A
VOLUME
DUAL ch1/ch2 setting
3
1
2
DIGITAL
dB
SIGNAL
SELECT
AC-3
SP
A
L
DIGITAL
VOLUME
When DUAL MONO is
playing with ch 1 selected
the L will light. When
playing with ch 2 selected
the R will light. When
playing with ch 1/2 selected
the L and R will light.
DUAL ch2 setting
Initial Set Up