Filter
Top Products
SET
UP
39
En
DYNAMIC RANGE CONTROL
This feature makes it possible to enjoy full surround sound effects on Dolby Digital sources even at low
volumes. It does this by compressing the dynamic range. Dynamic range is the difference between the loudest
and the softest sounds in any given signal. Compressing the range plays sounds so the quieter ones are audible
and the louder ones don’t get distorted or become overpowering. This feature only applies to Dolby Digital
sources but the MIDNIGHT LISTENING mode (explained on p.48) accomplishes the same end for a variety of
sources. If continuing from BASS PEAK LEVEL MANAGER go to step 1. If starting fresh, complete steps 1-3 in
“Setting Up for Surround Sound“ (p.30) first.
1
Press the DYNAMIC RANGE
CONTROL button.
2
Choose the amount of DYNAMIC
RANGE CONTROL, OFF, MID or
MAX, you want.
The default setting is OFF.
3
Press the SETUP OK button.
Hold the remote control pointed towards the amplifier
until you see the “RECEIVED” display on the
amplifier.
If "ERROR" flashes in the display, perform the setup
operations from the first step again.
dB
SIGNAL
SELECT
ANALOG
SP
A
VOLUME
This information will be displayed on your TV.
Dynamic Range Control
Select Mode [MID]
(For Dolby Digital)
If you want to change a setting before proceeding
Start over from step one.
You may need to experiment with different Dolby
Digital sources before you can use the DYNAMIC
RANGE CONTROL setting to suit your low volume
listening needs.
If you are listening at loud volumes we
recommend turning the Dynamic Range Control
OFF.
2
3
«
memo
Dynamic Range Control
BACK
SELECT MODE
FOR DOLBY DIGITAL
OFF MID MAX
SETUP
OK
Dynamic Range Control
SELECT MODE
FOR DOLBY DIGITAL
OFF MID MAX
SETUP
OK
BACK
SPEAKER
SETTING
CROSSOVER
NETWORK
BASS PEAK LEVEL
MANAGER
DYNAMIC RANGE
CONTROL
DIGITAL INPUT
SELECT
CHANNEL DELAY
CHANNEL LEVEL
System Setup
BACK
1
Initial Set Up