Filter
Top Products
OPERATION
OPERATION
59
En
Remote Control of Other Components
CD player operations
• The following operations are available from the Amplifier’s remote control after you program
your CD player into it, but some operations may need to be learned separately by the amplifier
(see “Setting Up the Remote Control to Control Other Components,“ p.52-55).
• To perform these operations, press the CD button to set the remote to the CD operation mode.
• For more information on individual commands consult the manual that came with the component.
1
Press to switch the CD player on or off (not
possible with all models, especially those without
a standby mode).
2 4˜¢
4 : Press to return to the beginning of the
current track. Press repeatedly to return to the
beginning of previous tracks.
¢ : Press to advance to the beginning of the
next track. Press repeatedly to advance to the
beginning of following tracks.
3 1˜¡
1 : Hold down for fast reverse playback.
¡ : Hold down for fast forward playback.
4 DISC
Use to switch between discs with file type disc
players.
5 7
Press to stop playback.
6 3
Press to start playback.
7 8
Press to pause playback.
8 Number buttons
Use to select tracks.
9 C
Use to clear tracks or programmed selections.
0 0/10
Use to select tracks with high numbers. The
button will increase the track number in
increments of ten.
- >10
You can also use this button when selecting track
numbers higher than 10.
= RDM
Use to select the random playback function. The
CD player will play all the tracks on the disc in a
random order.
~ Track
Use to select the track (not possible with all
models).
! PRGM
This button allows you to program a series of
tracks into the tracks into the CD player (may not
be possible with some CD players).
CD
1
2
4
7
8
9
5
6
3
DISC
RDM
TRACK
PRGM
C
10
0/10
0
1 !~ = -
2
3
4
5
6 7
9
8
memo