Filter
Top Products
60
En
MD operations
• The following operations are available from the Amplifier’s remote control after you program
your MD recorder into it, but some operations may need to be learned separately by the ampli-
fier (see “Setting Up the Remote Control to Control Other Components,“ p.52-55).
• To perform these operations, press the MD/TAPE1 button to set the remote to the MD operation
mode.
• For more information on individual commands consult the manual that came with the component.
Remote Control of Other Components
1
Press to switch the MD recorder on or off (not
possible with all models, especially those without
a standby mode).
2 4˜¢
4 : Press to return to the beginning of the
current track. Press repeatedly to return to the
beginning of previous tracks.
¢ : Press to advance to the beginning of the
next track. Press repeatedly to advance to the
beginning of following tracks.
3 1˜¡
1 : Hold down for fast reverse playback.
¡ : Hold down for fast forward playback.
4 ¶ REC
Press to start recording (may put some decks in
REC PAUSE mode).
5 7
Press to stop playback or recording.
6 3
Press to start playback.
7 8
Press to pause playback or recording.
8 Number buttons
Use to select tracks.
9 >10
You can also use this button when selecting track
numbers higher than 10.
0 0/10
Use to select tracks with high numbers. The
button will increase the track number in
increments of ten.
- NAME
Use to name tracks or programmed selections.
= EDIT MODE
Allows you to edit names and numbers of tracks.
~ DISP
Allows you to change the display mode of the MD.
! ENTER
Enters the changes yo have made in the EDIT
MODE.
0/10
MD
1
2
4
7
8
9
5
6
3
REC
EDIT
MODE
NAME
ENTER
DISP
>10
0
1 !~ = -
2
3
4
5
6 7
9
8
memo