Filter
Top Products
93
Troubleshooting Guide—Continued
“Not available with headphones use”
Operation not allowed because headphones are plugged
into the TX-NR801/TX-NR801E.
“Not available with Multichannel use”
Operation not allowed while the multichannel output is
being used.
“Not available in this Sp Config”
Will not work with the current speaker configuration
settings.
“Not available in Zone 2 mode”
Setting not allowed because the Zone 2 mode is turned
on.
“Only available with Dolby D”
No setting other than Dolby Digital can be set.
“Not available in this Listening mode”
Will not work with the current listening mode.
“Not available with this signal”
The listening mode cannot be selected with the current
input source.
“Not available in Pure Audio mode”
Will not work with the Pure Audio mode.
“Surr Back/Zone 2 setting is Surr Back”
Operation not allowed because the setting is Surr Back.
“Surr Back/Zone 2 setting is Zone 2”
Operation not allowed because the setting is Zone 2.
“Not available with Muting”
Operation not allowed because the muting is activated.
“Zone 2 is not On”
Will not work because Zone 2 has not been turned on.
Also refer to the respective instruction manuals of the
CD player, DVD player, video cassette recorder, TV
monitor, etc., that comprise your entertainment system.
The TX-NR801/TX-NR801E contains an internal
microcomputer that performs high-level operations.
However, on extremely rare occasions, noise or interfer-
ence from an external source or static electricity may
cause faulty operation. If this occurs, unplug the power
cord from the wall outlet, wait five or more seconds, and
then plug it back in. This should correct the situation.
* To reset the surround mode and other settings to the
factory default settings, hold down the VIDEO 1 but-
ton with the TX-NR801/TX-NR801E turned on and
then press the STANDBY/ON button. “CLEAR”
appears in the front display and the TX-NR801/
TX-NR801E enters the standby state.
If One of the Messages Shown Below
Appears