Filter
Top Products
40
Enjoying Music or Videos with the TX-NR801/TX-NR801E—Continued
Temporarily Changing the Speaker Output
Levels
To change the individual speaker volumes temporarily,
follow the procedure given below. Each channel can be
set between –12 and +12 decibels (between –15 and
+12 decibels for the subwoofer). Note that the speaker
volumes will return to the original settings when the
TX-NR801/TX-NR801E is put in the standby state.
Notes:
• You cannot select a speaker if it is set to “No” or
“None” in the Speaker Config Sub-menu of the
Speaker Setup Menu.
• To have your new speaker levels set here, overwrite
the settings at Setup Menu → Speaker Setup Menu
→ Level Calibration Sub-menu, and press the TEST
button after you complete step 3 in the procedure
above.
Using the Sleep Timer (remote controller only)
With the sleep timer you can set the TX-NR801/
TX-NR801E so that it automatically turns off after a set
period.
Adjusting the brightness of the front display
You can adjust the brightness of the front display of the
TX-NR801/TX-NR801E using the DIMMER button on
the remote controller or on the TX-NR801/TX-NR801E
front panel (other than European models).
1
Press the RCVR MODE button.
2
Press the CH SEL button and
select the desired speaker.
3
Press the LEVEL or button to
adjust the volume level.
DSP
A
-
FO
RM LISTENING MODE MEMORY
THX
SURROUNDDIRECT
/
PURE AUDIOSTEREO
FM
MODE
MEMORY
ENTER
RE
TURN
SETUP
TUNING
PRESET
DISPLAY DIMMER
AUDIO SELECTOR
TEST
RCVR
SLEEP
DISPLAY
DIMMER
CH SEL
AUDIO SEL
LEVEL
/
Press the [SLEEP] button repeat-
edly to select the required sleep
time.
You can set the sleep time from 90 to 10
minutes in 10 minute increments.
The SLEEP indicator appears on the dis-
play when the sleep timer has been set,
as shown. The specified sleep time
appears on the display for about five sec-
onds, then the previous display reap-
pears.
To cancel the sleep timer, press the
[SLEEP] button repeatedly until the
SLEEP indicator disappears.
To check the remaining sleep time,
press the [SLEEP] button. Note that if
you press the [SLEEP] button while the
sleep time is being displayed, you’ll
shorten the sleep time by 10 minutes.
Using the sleep timer only for Zone 2:
If you are using the remote zone (Zone
2), it will turn off at the same time as the
main zone. If you want to set the sleep
function for Zone 2 only, set the sleep
function with main zone turned on and
then put the main zone into the standby
state.
Use the DIMMER button to select:
dim, dimmer, or normal
brightness.
Remote
controller
DIMMER
TX-NR801/
TX-NR801E
Remote
controller