Filter
Top Products
73
Enjoying Net Audio
—Continued
a. DHCP/AUTO IP
Sets whether the network setting is configured automat-
ically or not.
On:
The network setting will be configured automati-
cally. When you set this option to On, the values for b.
through f. will be assigned using DHCP.
Off:
The network setting is configured manually.
b. IP Address
You will enter this value when you set the a. DHCP/
AUTO IP setting above to Off.
Enter the IP address assigned to your TX-NR801/
TX-NR801E. If your TX-NR801/TX-NR801E is
directly connected with an xDSL modem or terminal
adapter, be sure to enter the static IP address exactly as
specified by your ISP.
Specify the IP address within the range below. Net-Tune
Central cannot be used with IP addresses out of the
ranges below.
CLASS A:
10.0.0.0–10.255.255.255
CLASS B:
172.16.0.0–172.31.255.255
CLASS C:
192.168.0.0–192.168.255.255
Because the most of the commercially available routers
are set to a CLASS C IP address, specify a CLASS C IP
address for the TX-NR801/TX-NR801E.
c. SUBNET Mask
You will enter this value when you set the a. DHCP/
AUTO IP setting above to Off.
Enter the subnet mask. If your TX-NR801/TX-NR801E
is directly connected with an xDSL modem or terminal
adapter, be sure to enter the subnet mask exactly as spec-
ified by your ISP. Usually, enter 255.255.255.0 here.
d. Gateway
You will enter this value when you set the a. DHCP/
AUTO IP setting above to Off.
Enter the IP address of the default gateway. If your
TX-NR801/TX-NR801E is directly connected with an
xDSL modem or terminal adapter, be sure to enter the
gateway address exactly as specified by your ISP. If
your TX-NR801/TX-NR801E is connected to a gate-
way/router, enter the IP address of the gateway/router.
DNS Server
e. 1st
f. 2nd
You will enter this value when you set the a. DHCP/
AUTO IP setting above to Off.
Enter the IP address of the DNS server. If your
TX-NR801/TX-NR801E is directly connected with an
xDSL modem or terminal adapter, be sure to enter the
DNS address exactly as specified by your ISP.
When your Internet service provider provides only one
DNS address, enter this address into “e. 1st.” When two
or more DNS addresses are provided, enter both of them
into “e. 1st” and “f. 2nd,” respectively.
Note:
After setting, allow approx. 2 seconds until the
TX-NR801/TX-NR801E stores all of the data in the
memory. Be sure not to turn off the power during that
time otherwise the data will be lost.
Proxy Setup Sub-menu
Configure this item if your TX-NR801/TX-NR801E
uses a proxy server to connect to the Internet.
Enter the proxy server settings exactly as specified by
your ISP.
After the necessary settings are complete, press the
RETURN button to go back to “5. Network Setup
Menu,” select “
→
Save Settings,” and press the
ENTER button to save the setting you made.
a. Proxy Server
Sets whether the TX-NR801/TX-NR801E connects to
Internet radio station through proxy server or not.
On:
Connects to Internet radio station through Proxy
Server.
Off:
Connects to Internet radio station without Proxy
Server.
b. Proxy Address
Enter the domain name of the proxy server.
When you set a. Proxy Server to On, select this menu
item and press the ENTER or button, the
TX-NR801/TX-NR801E enters the character-entry
mode.
Select a character using the
/ / / buttons, and
press the ENTER button to enter the character.
After all the necessary characters are entered, the
TX-NR801/TX-NR801E exits the character-entry
mode.
c. Proxy Port
Enter the port number of the proxy server.
When you set a. Proxy Server to On, select this menu
item and press the ENTER or button, the
TX-NR801/TX-NR801E enters the number-entry
mode.
Select a number using the
/ / / buttons, and
press the ENTER button to enter the number.
After all the necessary numbers are entered, the
TX-NR801/TX-NR801E exits the number-entry mode.
Note:
After setting, allow approx. 2 seconds until the
TX-NR801/TX-NR801E stores all of the data in the
memory. Be sure not to turn off the power during that
time otherwise the data will be lost.
5-2.Proxy Setup
a.Proxy Server
:Off
b.Proxy Address
:
c.Proxy Port
: 0
Quit:[SETUP]