Filter
Top Products
67
Enjoying Music in the Remote Zone—Continued
To enjoy movies and audio in the remote zone (Zone 2),
you need to perform the remote zone settings.
The procedures shown below assume using the remote
controller. When performing these procedures using the
front panel, use the buttons corresponding to the ones on
the remote controller.
Performing the Settings for the
Remote Zone (Zone 2)
1
Press the SETUP button to display
the main menu on the monitor and
front display.
2
Use the and cursor buttons to
select “0. Hardware Setup” and
then press the ENTER button.
The “Hardware Setup” menu appears.
When the “Hardware Setup” menu item
does not appear, select “→Advanced
Menu” to display the “Advanced Menu.”
DSP
A
-
FO
RM LISTENING MODE MEMORY
THX
SURROUNDDIRECT
/
PURE AUDIOSTEREO
FM
MODE
MEMORY
ENTER
RE
TURN
SETUP
TUNING
PRESET
SETUP
ENTER
SETUP
ENTER
///
///
[ENTER]Quit:[SETUP]
Advanced Menu
0.Hardware Setup
1.Speaker Setup
2.Input Setup
3.Audio Adjust
4.Preference
5.Network Setup
→
Basic Menu
0.Hardware Setup
1.Speaker Impedance
2.Surr Back/Zone2
3.Remote Setup
4.TV Format
5.AM Frequency Step
[ENTER]Quit:[SETUP]
3
When you connect speakers
whose impedance values are
between 4 and 6 ohms, select
“Speaker Impedance” to display
the sub-menu and set the value for
the “Minimum” to “4 ohms.”
For details, see page 30.
Even if you connect some speakers
whose impedance values are between 6
and 16 ohms among speakers whose
impedance values are between 4 and 6
ohms, set the “Minimum” value to “4
ohms.”
4
Use the and cursor buttons to
select “Surr Back/Zone 2” and
then press the ENTER button.
The “Surr Back/Zone 2” menu appears.
5
Use the and cursor buttons
to select “Zone 2.”
6
Press the SETUP button to return
to the main menu.
0-1.Speaker Impedance
a.Minimum :6 ohms
Quit:[SETUP]
0-2.Surr Back/Zone2
a.Surr Back/Zone2
:Zone2
Quit:[SETUP]