Introduction Lexicon
ii
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
• Do not remove the cover from the unit.
• Do not insert anything into the unit through the ventila-
tion holes.
• Do not handle the mains lead with wet hands.
• Make a space of about .33ft (0.1m) around the unit.
Slots and openings on the case are provided for ventilation.
To ensure reliable operation of the unit, to protect it from
overheating, and to prevent fire hazard, these openings must
not be blocked or covered with items such as newspapers,
table cloths, or curtains. In addition, do not place the unit on
a thick carpet, bed, sofa, or fabric with a thick pile.
Before plugging in the unit for the first time, read the following
carefully: the available power supply voltage differs among
countries and regions. Make sure the power supply voltage
of the area where this unit will be used meets the required
voltage (e.g., 230V or 120V) written on the rear panel.
Do not place naked flame sources, such as lit candles, on the
unit. Naked flame sources might accidentally fall down,
causing fire to spread over the unit.
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radia-
tion exposure.
Note:
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
FOR CANADIAN MODEL:
This Class B digital apparatus complies with Canadian ICES-003.
POUR LE MODELE CANADIEN:
Cet appareil numérique de la Classe B est conforme à la norme NMB-003 due
Canada.
ATTENTION:
POUR ÉVITER LES CHOCS ÉLECTRIQUES INTRODUIRE LA LAME LA PLUS
LARGE DE LA FICHE DANS LA BORNE CORRESPON-DANTE DE LA PRISE ET
POUSSER JUSQU’AU FOND.
WARNING
WARNING
WARNING
CAUTION!
CLASS 1
KLASSE 1
LUOKAN 1
KLASS 1
PRODUCTO
LASER PRODUCT
LASER PRODUKT
LASER LAITE
LASER APPARAT
LASER CLASE 1