Filter
Top Products
RT-20 Universal Disc Player Getting Started
1-9
user guide. See “DISC COMPATIBILITY” on page 1-4, and “DISC
CARE & HANDLING” on page 1-8 for more information.
To load a disc:
1. Press the Open/Close button to open the disc drawer.
2. If the disc drawer is not empty, remove the disc loaded in the
disc drawer.
3. When the disc drawer is empty, load the desired disc in the disc
drawer.
Load single-sided discs with the label side facing upward. Load
double-sided discs with the label for the side intended for play-
back facing upward. All discs must align with the circular guide
inside the disc drawer.
4. When the desired disc has been loaded, press the Open/Close
button to close the disc drawer. The disc drawer can also be
closed with a gentle press against the front of the disc drawer.
REMOTE CONTROL BATTERY INSTALLATION
The remote control requires two AA batteries that should be
replaced as needed. Use alkaline batteries for best results.
To replace the remote control batteries:
1. Locate the battery compartment on the back of the remote
control. Press the tab and lift the cover away from the remote
control.
2. Remove old batteries (if applicable).
3. Observing the proper polarity, insert two AA batteries.
4. Align the cover over the battery compartment and gently press
down until it snaps back into place. Dispose of the old batteries
(if applicable).
5. See the “Remote Control Command Matrix” on page 2-13
before operating the remote control.