Filter
Top Products
Appendices
85
Can’t record two tracks simultaneously
The “EFFECT ASSIGN” (effect insert location) may
have been set to “GUITAR/MIC.”
→ If this is set to “GUITAR/MIC,” only one track can be
recorded simultaneously.
Input sound or recorded sound contains noise or distortion
Is the [INPUT LEVEL] knob raised to an appropriate
level?
→ The sound will distort if the [INPUT LEVEL] knob set-
ting is too high, or will be noisy if the setting is too
low. (→p.21)
If the input to the effect is distorted, make the follow-
ing adjustments.
Guitar/insert effect: Use the [INPUT LEVEL] knob
etc. to adjust the volume as high as possible without
allowing the [INPUT LEVEL] LED to light.
Master effect: Adjust the faders and send level so that
“CLIP” for the master L/R track does not light.
Final effect: Adjust the faders so that “CLIP” does not
light for the master L/R track.
If the effect output is distorted, make the following
adjustments.
Guitar/insert effect: Adjust the effect parameters and
[INPUT LEVEL] while listening to the sound.
Master/final effect: Adjust the effect parameters so
that “CLIP” for the master L/R track does not light.
Effect does not apply
Tuner mode may have been selected.
→ The effect will be bypassed (off) when the tuner is
selected.
Is the master volume of the effect program set to “0”
or close to “0”?
→ Press an effect type key (e.g., [GUITAR/MIC]) and
then press the CURSOR [ ] key several times to make
the display read “ProgMVol,” and adjust the volume.
Is the [INPUT LEVEL] knob raised to an appropriate
level?
→ The effect may not be applied if the [INPUT LEVEL]
knob value is too low.
Guitar/insert effect does not apply
Is the effect insert location appropriate?
→ Press the FX [GUITAR/MIC] or [INSERT/GTR+VO]
key to choose “GUITAR/MIC” or “INSERT/
GTR+VO” as the effect type. (→p.37)
It is not possible to use a guitar/insert effect on a play-
back track.
Master effect does not apply
Is the effect insert location correct?
→ Press the FX [MASTER] key to choose “MASTER” as
the effect type. (→p.38)
Is the send level from each track set to “0”or close to
“0”?
→ Press the [SEL] key to select “SEND,” and use the
[PAN] knobs to adjust the send levels of each track.
Is the return level set to “0” or close to “0”?
→ Press the [SEL] key to select “SEND,” and then use the
[RETURN] knob to adjust the return level.
Final effect does not apply
Is the effect insert location correct?
→ Press the FX [FINAL] key to choose “FINAL” as the
effect type. (→p.38)