Filter
Top Products
Mode parameters
57
SYSTEM
P.1 MixerSys: Mixer settings
1. AutoIn ................................................................ [Off, On]
If this setting is on, the input source for the track(s) that
are record-enabled by “REC SELECT” will be automati-
cally switched according to the state of the recorder.
When using punch recording, we suggest you turn this
setting “On.”
On: For tracks selected for recording, the input will be
switched automatically according to the status of the
recorder:
External input when the recorder is stopped
Track play back when the recorder is playing
External input when the recorder is recording
Off: Tracks selected for recording will always use the
external input.
2. AutoPan ............................................................. [Off, On]
If AutoPan is “On,” pan settings will be made automati-
cally when you bounce-record to a single track.
3. SubIn.................................................................. [Off, On]
Turn SubIn “On” when you want to insert an external
input directly into the master bus. Otherwise leave this
turned “Off.” (→p.51)
4. LocMoni (LocateWithMonitoring).......................... [Off, On]
This function outputs the track playback in order to help
you verify the location when you change the current time
in the Locate page. The track audio of channels selected
for recording will be output if “AutoIn” is “On.”
P.2 Foot SW: Foot switch settings
1. Pol: ..........................................................................[+, –]
This specifies the polarity of the foot switch connected to
the FOOT SW jack. An “*” is displayed when you press
the foot switch to turn it on.
P.3 UndoSys: Undo settings
1. AutoUndo........................................................... [Off, On]
Select whether the Undo/Redo function will be available.
On: Undo/Redo will be available.
After recording or track editing, you will be able to undo/
redo.
Off: Undo/Redo will not be available.
If this is “On,” the undo data will be erased following the
next recording or track editing operation. If you turn this
“On” again without performing a recording or track editing
operation, undo/redo will be available.
2. DelUndo? ...........................................................[#.S, ALL]
You can delete the undo data to increase the free space on
the card.
Press the CURSOR [ ] key to select “Yes,” and the data
will be deleted.
Undo data that has been deleted cannot be recovered.
#.S: Delete only the undo data of the currently selected song.
ALL: Delete the undo data of all songs.