Filter
Top Products
84
6
Pressing ui, select the rst letter of the device brand
name. Then press ENTER.
1
A
B
C
D
E
RemoteSetupGuide
[1/4]
Please select the
first letter of the
brand name
of the device.
DVD
[CH+/-]Page+/-
•The first character is displayed as 1, A to Z.
(Initials for the brand are displayed for each
category.)
For brand names that start with numbers
and symbols, select “1”.
•When there are several pages of brand
names, the pages can be switched by
pressing the remote control unit’s CH + or
CH –.
7
Pressing ui, select the device
brand name. Then press ENTER.
Dantax
Denon
Disney
DSE
Durabrand
Please select the
brand name.
DVD
RemoteSetupGuide
•When there are several pages of brand names, the pages can be
switched by pressing the remote control unit’s CH + or CH –.
NOTE
If the desired brand name is not listed, the supplied remote control
unit cannot control the device. Use the remote control unit supplied
with the device to be used.
Registering preset codes
8
The procedures for registering remote control codes
and remote control preset registration are displayed.
DVD
Denon
30490[1/3]
Device
Brand
Code
1.Press[INPUT SOURCE].
2.Press and hold [DEVICE ON(I)]
for 3 seconds.
3.Input Code with [0-9].
4.Press any key to check device.
OK[QUICK1] NG[QUICK2] Return[QUICK3]
RemoteSetupGuide
NOTE
If a wrong brand name is selected, press
QUICK SELECT 3. The following screen is
displayed:
Input source
select buttons
Press [AMP] button. And press
[ENTER] button to return Brand
select menu.
RemoteSetupGuide
O K
Press AMP then ENTER to return to step 7.
9
Press the input source button
on which the preset code is to
be registered (BD, SAT/CBL, TV,
DVD, V.AUX, DOCK, GAME1,
GAME2 or CD).
Input source
select buttons
•For TV, only the preset code for the
categories “TV”, “TV/DVD” or “TV/VCR”
can be registered.
10
Press and hold ZONE/DEVICE Z
for at least 3 seconds.
The zone mode indicator ashes
twice.
11
Enter a ve-digit code using 0 – 9.
Press the buttons with an interval less than 10 seconds.
DVD
Denon
30490[1/3]
Device
Brand
Code
1.Press[INPUT SOURCE].
2.Press and hold [DEVICE ON(I)]
for 3 seconds.
3.Input Code with [0-9].
4.Press any key to check device.
OK[QUICK1] NG[QUICK2] Return[QUICK3]
RemoteSetupGuide
•When the code is registered.
Thezonemodeindicatorashestwice.
•When the code is not registered correctly
The mode indicator slowly flashes once. Perform from step 9
again.
•When an input number is not correct
Press ON once then perform the operations from step 9 again.
12
Operate the device being used to
check the operation.
•If the device is operating, press QUICK SELECT 1.
Go to step 13.
•If the device is not operating, press QUICK SELECT 2.
Go to step 14.
Basic version
Advanced version
Information
Advanced version
vSee overleaf
BD