Filter
Top Products
52
Playback
1
Press ZONE SELECT to switch the
zone mode to K (ZONE2).
Input source
select buttons
2
Press AMP to set the remote
control unit to AMP-operation
mode.
3
Press ZONE/DEVICE Z to turn on
the ZONE2 power.
The indicator on the display lights.
•Also press input source select button when
in standby mode, the power turns on.
•When ZONE/DEVICE X is pressed, ZONE2
turns off.
•Power in ZONE2 can be turned on or off by
pressing ZONE2 ON/OFF on the main unit.
4
Press the input source select
button.
The audio signal of the selected source
is output to ZONE2.
•To perform an operation with the main unit, press
ZONE2 SELECT
many times.
When power for both MAIN ZONE and ZONE2 is set to ON, power
of the MAIN ZONE only can be turned off. Select J (MAIN ZONE) in
step 1 then press ZONE/DEVICE X.
Adjusting the volume
Use M df to adjust the volume.
GAdjustable rangeH
– – –
–80dB – –40dB – 18dB
(When the “Volume Display” (vpage73) setting is “Relative”)
GAdjustable rangeH
0 – 41 – 99
(When the “Volume Display” (vpage73) setting is “Absolute”)
•At time of purchase, “Volume Limit” (vpage 73) is set to
“–10dB (71)”.
Turn MASTER VOLUME after pressing ZONE2 SELECT on the main
unit to adjust the sound volume.
Turning off the sound temporarily
Press N.
The sound is reduced to the level set at “Mute Level” (vpage73)
in the menu.
•To cancel, either adjust the volume or press N again.
•Thesettingiscanceledwhenthezone’spoweristurnedoff.
Basic version
Advanced version
Information
Advanced version
vSee overleaf
BD