Filter
Top Products
75
System Setup
Setting items Setting details
Firmware Update
Update the firmware of the
receiver.
NOTE
If the unit cannot connect to
the network after updating
the firmware, setup the
network connection again
through “Network Setup”
(vpage70) in the menu.
Check for Update : Check for firmware updates. You can also check
approximately how long it will take to complete an update.
Start : Execute the update process.
When updating starts, the power indicator becomes red and the menu
screen is shut down. The amount of update time which has elapsed is
displayed.
When updating is complete, the power indicator becomes green and
normal status is resumed.
•If updating fails, the set automatically retries, but if updating is still not
possible, one of the messages shown below is displayed. If the display
reads as shown below, check the settings and network environment,
then update again.
Display Description
Updating fail Updating failed.
Login failed Failure to log into server.
Server is busy Server is busy. Wait a while then try again.
Connection fail Failure in connecting to server.
Download fail Downloading of the firmware has failed.
Add New Feature
Display new features that
can be downloaded to this
unit and perform an update.
NOTE
If the unit cannot connect
to the network after adding
a new feature, setup the
network connection again
through “Network Setup”
(vpage70) in the menu.
Upgrade : Execute the upgrade process.
When updating starts, the power indicator becomes red and the menu
screen is shut down. The amount of update time which has elapsed is
displayed.
When upgrading is complete, the power indicator becomes green and
normal status is resumed.
•If the upgrade is not successful, an error message identical to those in
“Firmware Update” will appear on the display. Check the settings and
network environment, then update again.
Upgrade Status : Display a list of the additional functions provided by the
upgrade.
See the D&M Professional website for details about updates.
When the procedure is complete, “Registered” is displayed in this
menu and updates can be carried out. If the procedure has not been
carried out, “Not Registered” is displayed.
The ID number shown on this screen is needed when carrying out the
procedure.
The ID number can also be displayed by pressing and holding the main
unit’s QUICK SELECT 3 and iPod 1 for at least 3 seconds.
Notes concerning use of “Firmware Update” and “Add New Feature”
•In order to use these functions, you must have the correct system requirements and settings for a
broadband Internet connection (vpage15).
•Do not turn off the power until updating or upgrading is completed.
•EvenwithabroadbandconnectiontotheInternet,approximately1hourisrequiredfortheupdating/
upgrading procedure to be completed.
•Onceupdating/upgrade starts,normal operationsonthis unitcannotbe performeduntil updating/
upgrading is completed.
•Furthermore,updating/upgradingthermwaremayresetthebackupdatafortheparameters,etc.set
for this unit.
•If the update or upgrade fails, press and hold the ON/STANDBY on the main unit for more than 5
seconds, or remove and re-insert the power cord. “Update retry” appears on the display and update
restarts from the point at which update failed. If the error continues despite this, check the network
environment.
•Information regarding the “Firmware Update” function and “Add New Feature” will be announced on
the D&M Professional web site each time related plans are defined.
•When usable new firmware is released with “Firmware Update” or “Add New Feature”, a notification
message is displayed on the menu screen. When you do not want to be notified, set “Notification” –
“Update” (vpage72) and “Upgrade” (vpage72) to “OFF”.
Basic version
Advanced version
Information
Advanced version
BD