Denon DN-500AV Home Theater System User Manual


  Open as PDF
of 139
 
69
System Setup
Audio Setup
Default settings are underlined.
Make settings for audio playback.
Setting items Setting details
2ch Direct/Stereo
Select the method for
setting the speakers used
in the 2-channel direct and
stereo playback modes.
Setting : Select the method for setting the speakers used in the 2-channel
direct and stereo playback modes.
•Basic : The settings at “Speaker Setup” (vpage65) are applied.
•Custom : Make separate settings for 2-channel. Make the following
settings:
Front:Setthefrontspeakersize.
•Large : Use a large speaker that can adequately play back low
frequencies.
•Small : Use a small speaker that has inadequate playback capacity for
low frequencies.
If “Speaker Config.” – “Subwoofer” (vpage65) is set to “No”,
the setting is automatically set to “Large”.
SW : Set the presence of a subwoofer.
•Yes : Use a subwoofer.
•No : Select when a subwoofer is not connected.
If “Speaker Config.” – “Subwoofer” (vpage65) is set to “No”,
the setting is automatically set to “No”. If the “Front” setting is
“Small”, the setting is automatically “Yes”.
SW Mode : Select low range signals to be reproduced by subwoofer.
•LFE:Whenthe“2chDirect/Stereo”–“Front”settingissetto“Large”,
the LFE signal alone is output from the subwoofer. Also, when the “2ch
Direct/Stereo”–“Front”settingissetto“Small”,thefrontchannellow
range signal is added to the LFE signal output from the subwoofer.
•LFE+Main : The front channel low range signal is added to the LFE signal
output from the subwoofer.
Thissettingcanbesetmade“2chDirect/Stereo”–“SW”issetto
“Yes”.
Crossover : Set the maximum frequency of the bass signal output from
each channel to the subwoofer.
•40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
250Hz
•This setting canbe set made “2ch Direct/Stereo”– “SW” is set to
“Yes”.
•Ifthe“2ch Direct/Stereo”–“Front” settingis“Large” andthe“SW
Mode” setting is “LFE”, “Full Band” is displayed and the setting cannot
be made.
Setting items Setting details
2ch Direct/Stereo
(Continued)
Distance FL/Distance FR : Select the speaker.
•0.0ft – 60.0ft (12.0ft)/0.00m – 18.00m (3.6m) : Set the distance to the
speaker.
Set the difference in the distance between the speakers to less than
20.0 ft (6.00 m).
Level FL / Level FR : Select the speaker.
•–12.0dB – +12.0dB (0.0dB) : Adjust the level of each channel.
Auto Surround
Make setting for
memorizingsurroundmode
setting for each input signal
type.
ON:Memorizesettings.Automaticallyplaywiththelastusedsurround
mode.
OFF : Do not memorize settings. Surround mode does not change
according to input signal.
•The auto surround mode function lets you store in the memory the
surround mode last used for playing the four types of input signals listed
below.
q Analog and PCM 2-channel signals
w Dolby Digital and DTS 2-channel signals
e Dolby Digital and DTS multi-channel signals
r LPCM Multi-channel signals
•When playing in PURE DIRECT, the surround mode does not change
even if the input signal is changed.
Basic version
Advanced version
Information
Advanced version
BD
 previous next