Denon DN-500AV Home Theater System User Manual


  Open as PDF
of 139
 
74
System Setup
Setting items Setting details
GUI
Make the settings related to
displays on the TV screen.
Screensaver : Make screensaver settings.
•ON : The screensaver is activated during menu
display,NET/USBoriPodscreendisplayifno
operation is performed for an approximately
5-minute continuous period. When you press
uio p, the screensaver is cancelled and
the screen before that screen saver started is
displayed.
•OFF : Screensaver is not activated.
Format : Set the video signal format to be output for the TV you are using.
•NTSC : Select NTSC output.
•PAL : Select PAL output.
“Format” can also be set by the following procedure. However, the menu
screen is not displayed.
1. Press and hold the main unit’s QUICK SELECT 1 and SLEEP for at least
3 seconds.
“V.Format:<PAL>” appears on the display.
2. Press the main unit’s QUICK SELECT 2, QUICK SELECT 3 and set the
video signal format.
3. Press the main unit’s iPod 1 to complete the setting.
NOTE
When a format other than the video format of the connected TV is set, the
picture will not be displayed properly.
Text : Display the details of operation when switching surround mode,
input mode, etc.
•ON : Turn display on.
•OFF : Turn display off.
Master Volume : Display the master volume during adjustment.
•Bottom : Display at the bottom.
•Top : Display at the top.
•OFF : Turn display off.
When the master volume display is hard to see when superimposed
on movie subtitles, set to “Top”.
NET/USB:SettheNET/USBscreendisplaytimewhentheinputsource
is“NET/USB”.
•Always : Show display continuously.
•30s : Show display for 30 seconds after operation.
•10s : Show display for 10 seconds after operation.
•OFF : Turn display off.
Setting items Setting details
GUI
(Continued)
iPod : Set the iPod screen display time when the input source is “DOCK”
or “iPod (USB)”.
•Always : Show display continuously.
•30s : Show display for 30 seconds after operation.
•10s : Show display for 10 seconds after operation.
•OFF : Turn display off.
Remote Setup Guide
Search a preset code to
register in the remote
control unit.
See “Registering preset codes” (vpage83).
Quick Sel.Name
Change the “Quick Select”
display title to one you
prefer.
•Up to 16 characters can be input.
•For character input, see page57.
Zone Rename
Change the display title of
eachzonetooneyouprefer.
•Up to 10 characters can be input.
•For character input, see page57.
Dimmer
Adjust the display
brightness of this unit.
Bright : Normal display brightness.
Dim : Reduced display brightness.
Dark : Very low display brightness.
OFF : Turns the display off.
Buttons on the main unit can be used for operations.
Each time DIMMER is pressed, the setting is changed as shown
below.
Bright Dim
DarkOFF
Setup Lock
Protect settings from
inadvertent change.
ON : Turn protection on.
OFF : Turn protection off.
When canceling the setting, set “Setup Lock” to “OFF”.
NOTE
When “Setup Lock” is set to “ON”, the settings listed below can no
longerbechanged.Also,“SETUPLOCKED!”isdisplayedifyouattempt
to operate related settings.
•Menu operations •Channel Level
Basic version
Advanced version
Information
Advanced version
vSee overleaf
BD
 previous next