66
System Setup
Setting items Setting details
Speaker Config.
(Continued)
F.Height:Setthepresenceandsizeofthefrontheightspeakers.
•Large : Use a large speaker that can adequately play back low
frequencies.
•Small : Use a small speaker that has inadequate playback capacity for
low frequencies.
•None : Select when the front height speakers are not connected.
NOTE
When “Amp Assign” setting (vpage 65) is “F.HEIGHT”, you can
make the “F.Height” setting.
Bass Setting
Set subwoofer and LFE
signal range playback.
Subwoofer Mode : Select low range signals to be reproduced by
subwoofer.
•LFE:Thelowrangesignalofthechannelsetto“Small”speakersizeis
added to the LFE signal output from the subwoofer.
•LFE+Main : The low range signal of all channels is added to the LFE
signal output from the subwoofer.
•“Subwoofer Mode” can be set when “Speaker Config.” – “Subwoofer”
(vpage65) is set to “Yes”.
•Play music or a movie source and select the mode offering the strongest
bass.
•Select “LFE+Main” if you want the bass signals to always be produced
from the subwoofer.
NOTE
If “Front” and “Center” for “Speaker Config.” are set to “Large”, and
“Subwoofer Mode” is set to “LFE”, no sound may be output from the
subwoofers, depending on the input signal or selected surround mode.
LPF for LFE : Set LFE signal playback range. Set this when you want to
change the playback frequency of the subwoofer.
•80Hz/90Hz/100Hz/110Hz/120Hz/150Hz/200Hz/250Hz
Setting items Setting details
Distance
Set distance from listening
position to speakers.
Measure beforehand the
distance from the listening
position to each speaker.
Unit : Set the unit of distance.
•Meters/Feet
Step : Set the minimum variable width of the distance.
•0.1m/0.01m
•1ft/0.1ft
Default : The “Distance” settings are returned to the default settings.
•Yes : Reset to the defaults.
•No : Do not reset to the defaults.
When you select “Default” and press ENTER,
the “Return settings to the default?” prompt
is displayed. Select either “Yes” or “No”, and
press ENTER.
Front L/Front R/Center/Subwoofer/Surround L/Surround R/
S.Back L
z
/S.Back R
z
/F.Height L/F.Height R : Select the speaker.
z When the “Speaker Config.” – “S.Back” setting (vpage65) is set
to “1spkr”, “S.Back” is displayed.
•0.00m – 18.00m/0.0ft – 60.0ft : Set the distance.
•The speakers that can be selected differ depending on the “Amp Assign”
(vpage65) and “Speaker Config.” (vpage65) settings.
•Default settings :
FrontL/FrontR/Center/Subwoofer/F.HeightL/F.HeightR:3.60m
(12.0 ft)
SurroundL/SurroundR/S.BackL/S.BackR:3.00m(10.0ft)
•Set the difference in the distance between the speakers to less than
6.00 m (20.0 ft).
NOTE
Speakers set to “None” in “Speaker Config.” (vpage 65) are not
displayed.
Basic version
Advanced version
Information
Advanced version
vSee overleaf
BD