Filter
Top Products
Operation
CineWall™ Installer/Integrator Manual 63
PRE
L
IMINAR
Y
Memory Presets For each input, the CineWall lets you save image quality settings as presets that you can
recall at a later time. You can create up to four presets per input and display mode
(resolution and frame rate).
The DHD Controller stores the following display modes in each memory preset:
• 480i
• 480p
• 576i
• 576p
• 720p/24 Hz
• 720p/25 Hz
• 720p/30 Hz
• 720p/50 Hz
• 720p/60 Hz
• 1080i/50 Hz
• 1080i/50 Hz (Australia)
• 1080i/60 Hz
• 1080p/24 Hz
• 1080p/25 Hz
• 1080p/30 Hz
• 1080p/50 Hz
• 1080p/60 Hz
Use the Memory Presets menu to recall saved image presets, or to save image settings in
the “Custom 1” or “Custom 2” memory location. The currently-selected preset is indicated
by a “
➡” to its left; in the example shown here, ISF Night is selected.
You should save changes to any of the following settings to a preset; otherwise they will
be lost when a new input source or resolution is selected:
• Brightness
• Contrast
• Color Saturation
• Tint
• Sharpness
• Gamma
• Lamp settings
• Color Temp and white balance (Gain, Offset)
To select a memory preset, press or to highlight it and press ENTER.
To save the settings for the current input and display mode to the Custom 1 or Custom 2
memory preset, select it, press
or to highlight Save and press ENTER.
Memory Presets
➡
ISF Night
ISF Day
Custom 1 Save Reset
Custom 2 Save Reset
To save the settings for the current input and display mode to the
ISF
Night or ISF Day memory preset, select Save ISF Night or Save
ISF Day from the Calibration menu (refer to Save ISF Night/Save
ISF Day on page 67).
Note