Filter
Top Products
Installation
46 CineWall™ Installer/Integrator Manual
PRE
L
IMINAR
Y
4.7
Installing Batteries in
the DHD Controller
Remote Control
To install batteries in the DHD Controller remote control:
1. Press down the tab on the cover and
pull the cover in the direction of the
arrow.
2. Insert the included batteries. Ensure
that the polarities correctly match the
and markings inside the battery
compartment.
3. Insert the lower tab of the cover into the
opening, and press down the cover until
it clicks in place.
Notes on Batteries • When installing batteries, make sure that the battery polarities are correct.
• Do not mix an old battery with a new one or different types of batteries.
• If you will not use the remote control for a long time, remove the batteries to avoid
damage from battery leakage.
Notes on Remote Control
Operation
The remote control can be used to control the CineWall within the ranges shown in Figure
4-13.
Figure 4-13. Available Range of the Remote Control
• Do not drop the remote control or expose it to moisture or high temperature.
• The remote control may malfunction under a fluorescent lamp. If that occurs, move the
plasma display away from the fluorescent lamp.
➤
➤
r
a
t
i
o
r
a
t
i
o
i
n
p
u
t
standby
m
e
n
u
i
n
p
u
t
e
n
t
e
r
3
HDMI 1
16:9 1080i/60
CUST
1
CUST
2
SVC
HDMI
1
HDMI
2
EXIT
RETURN
16 : 9
4 : 3
Approx.
40 feet
(12.2 meters)
Approx.
30º
Approx.
30º