Filter
Top Products
Installation
CineWall™ Installer/Integrator Manual 47
PRE
L
IMINAR
Y
• Make sure that there is nothing obstructing the infrared beam between the remote
control and the IR receiver on the plasma display.
• If the effective range of the remote control decreases, or it stops working, replace the
batteries with new ones.
• Ambient conditions may possibly impede the operation of the remote control. If this
happens, point the remote control at the plasma display and repeat the operation.
4.8
Powering Up the
CineWall and DHD
Controller
Connecting the DHD
Controller to AC Power
Plug the female end of the power cord into the AC receptacle
on the rear of the DHD Controller. Then, connect the other
end to your AC power source (AC 100V ~ 240V).
1. Turn on your source components.
2. Return the strut to the closed position and close the screen.
3. Gently press on the bottom left and right corners to engage the latches at the bottom
of the screen.
4. Set the main power switch on the DHD Controller to the ON position.
5. Press the ON button on the remote control (or the ON/STANDBY ( ) button on
DHD Controller front panel) to turn on the system. The vacuum fluorescent display on
the DHD Controller front panel briefly displays “Starting Display.”
6. When the CineWall is ready for use, the fluorescent display indicates the active
source, input resolution/frame rate and aspect ratio; for example:
The signal from the remote control can be reflected by walls or
other surfaces.
Note
CW-95DHD HDMI 1
16:9 1080i/60
Current
Source
Aspect Ratio
Input Resolution/Frame Rate