Filter
Top Products
Customizing SoundStructure Designs
5 - 15
meter will show less signal activity.
Since the level_pre meter position is before any processing has been applied to
the signal, even if the signal is muted within the SoundStructure device, the
level_pre input meter will show any signal activity on that input.
The level_post meter is after any processing as shown in the following figure.
In the example above, if the input signal is muted the level_post meter will not
show any signal activity.
The exact location of the meter in the signal processing path depends on the
type of signal that is viewed as described next.
Microphone level_post
Microphone channels post level will measure the signal level at the conferenc-
ing output of the input processing as shown in the following figure.
The fader on the bottom of the input channel can be used to adjust the gain of
the output of the input processing. The fader will change the level of all three
outputs going to the matrix. The meter activity will show the affect of any gain
Mic or Line
Input
Input to
Matrix
Input to
Matrix
Parametric
Equalization
A/D
Converter
Analog
Gain
Acoustic Echo
Cancellation
Noise
Cancellation
Automatic
Gain Control
Automixer
AGC Dynamics Fader Delay
Fader
Automixer
Automixer
Delay
Automatic
Gain Control
Non Linear
Processing
Feedback
Cancellation
Dynamics
Processor
Dynamics
Processor
Fader
Input to
Matrix
Automatic
Gain Control
Fader Delay
Dynamics
Processor
Delay
Mute
Router
Recording/
Ungated
Conferencing
Sound
Reinforcement
C-Series Input Processing
Input to
Matrix
Input to
Matrix
ay
ay
Input to
Matrix
ay
ay
Mute
Recording/
Ungated
Conferencing
Sound
Reinforcement
Microphone Post Processing Meter
level_post
level_post