Filter
Top Products
Using other functions
09
78
En
Switching the speaker impedance
• Default setting: Speaker 6ΩΩ
ΩΩ
We recommend using speakers of 6Ω to 16Ω with this
system, but it is possible to switch the impedance setting
if you plan to use speakers with a lower impedance rating
(for example, less than 6Ω).
• With the receiver in standby, press STANDBY/
ON while holding down the OPTION – button.
Each time you do this, you switch between the
impedance settings:
• Speaker 4ΩΩ
ΩΩ
– Use this setting if your speakers are
rated lower than 6Ω.
• Speaker 6ΩΩ
ΩΩ
– Use this setting if your speakers are
rated 6Ω or more.
Note
• If you select Speaker 4ΩΩ
ΩΩ
above, the Stream Direct
setting is fixed at SD:1 NORMAL (see Using the
Stream Direct mode on page 47).
Checking your system settings
Use the status display screen to check the various
settings you’ve made for features such as sound delay,
digital noise reduction, and high-sampling.
1 From the remote control receiver menu, press
STATUS to check the system settings.
You may need to press on the Home menu ( )
first before reaching the receiver menu screen shown
below (use the / (cursor left/right) soft keys to go to
the previous/next menu screen).
These appear on both the OSD and the front panel
display.
The front panel display shows each of the following
settings for two seconds each:
Note
• If the Stream Direct mode is switched on, some
settings above will show OFF, even though they are
switched on.
2 When you’re finished, press STATUS again to
switch off the display.
STANDBY/ON
OFF ON
STANDBY
DVD/LD TV/DVD SAT VIDEO
VIDEO AUDIO
DVR/VCR1 VCR2 VCR3 CD TUNER
P
CD-R/
TAPE1/MD
INPUT SELECTOR
PHONES
SP SYSTEM
A/B
SIGNAL
SELECT
VIDEO
SELECT
TAPE2
MONITOR
STREAM
DIRECT
SETUP
MIC
SB CH
MODE
DIGITAL IN
S-VIDEO VIDEO
VIDEO INPUT
AUDIOLR
MIDNIGHT
TONE OPTION DIGITAL NR CLASS STATION
MULTI ROOM & SOURCE
CONTROL ON/OFF
TUNER
ACOUSTIC
CAL.
Surround back speaker/
Virtual back speaker
Video select
Acoustic calibration EQ Dual mono
Digital noise reduction Sound delay
Midnight Hi-bit
Loudness High-sampling
Tone Real phantom
RECEIVER
RECEIVER
3/4
SB CH
MODE
INPUT
STATUS
INPUT
AT T
SPEAKER
A/B
VIDEO
SELECT
TAPE2
MONITOR
DISPLAY
DIMMER
RECEIVER
TV
CONT
SB CH MODE :
ACOUS. CAL EQ :
DIGITAL NR :
MIDNIGHT :
LOUDNESS :
TONE CONTROL :
VIDEO SELECT :
DUAL MONO :
SOUND DELAY :
HI-BIT :
HI-SAMPLING :
REAL PHANTOM :
ALL ADJ
OFF
ON
DVD/LD
CH1
0.0frame
OFF
OFF
OFF
OFF
OFF
OFF