Filter
Top Products
Controlling other equipment
08
73
En
• You don't need to program the receiver to switch to
the input function selected in step 2, or to switch on
or off. This is done automatically.
With Pioneer components, you don’t need to:
• program the power to switch off in a shutdown
sequence;
• program the power to switch on if it’s the source
component selected in step 2;
• program a Pioneer TV or monitor to switch on if the
input function (selected in step 2) has video input
terminals;
These take priority in multi operations (not shutdown).
5 If necessary, add a delay between operations by
pressing ‘Delay’.
Some components may take a few seconds to switch on
or off, or perform certain operations. In these cases, you
may want to add a slight delay (up to sixty seconds is
possible) between commands.
Use the + and – buttons on the Delay Time screen to
adjust the delay time then press OK.
• If you want to change the delay time after it’s been
set, press the delay time, then press SET to come
back to this screen.
6 Repeat steps 3 to 5 for additional commands.
As each command is entered, they will appear in order on
the remote touch screen.
• To test the sequence before confirming it, press Run.
• To replace a command in the sequence, select the
command then press Replace. Add the operation as
shown in the steps above.
• To add a new command above another command,
press the existing command before pressing Add.
• To erase a command, select the operation you want
to erase and press Delete.
• Commands will be stored regardless of how you exit
from this screen.
7 Press OK when you’re finished.
PLEASE WAIT shows in the remote display while the
multi operation is stored and you’ll return to step 2.
Using multi operations
You can start multi operations with the receiver switched
on, or in standby.
1 From the remote control Home menu press
MULTI OPERATION.
2 Press a function button that has been set up with
a multi operation.
The receiver switches on (if it was in standby) and the
programmed multi operation is performed automatically.
MULTI OPERATION
DVD/LD
CANCELOK
Delay Time
0.1 sec
+
–
MULTI OPERATION
DVD/LD
Add
DVD -
PLAY
Delay - 2.0sec
Replace
Run
Delete
Delay OK
HOME
SYSTEM
OFF
TV
CONT
MULTI
OPERATION
TV
/ DVD
DVD
/ LD
DVR
/ VCR1
SAT
INPUT 1 2 3
CD TUNER
SETUP
RECEIVER
RECEIVER
1/3
MULTI OPERATION
TV
CONT
MULTI CH
INPUT
VIDEO
VCR2
CD-R
/ TAPE1
CD
VCR3
DVD
/ LD
TV
/ DVD
SAT
Select Function
DVR
/ VCR1
TUNER
CANCEL