Filter
Top Products
Operations Manual, HPA2, Compact Outdoor SSPA 205486 REV F 23
3. Bring the unit up tight under the boom (with the long axes parallel), sliding the All-Thread
studs past the sides of the boom to show above the boom top. Place the remaining pieces
of Uni-strut (open channel down) across the boom, onto the protruding All-Thread stud
ends. Secure firmly with a flat washer and ½” nut on each of the four All-Thread stud
ends. Looking from the end of the boom, the mounted unit should look as shown in Figure
2-12.
4. Connect the Compact Outdoor SSPA unit’s power source, RF Input and RF Output as
directed elsewhere in this manual.
DO NOT APPLY POWER TO THE COMPACT OUTDOOR UNIT BEFORE
TERMINATING THE RF OUTPUT CONNECTOR.
Figure 2-12: Compact Outdoor Mounting Completed