Filter
Top Products
22 205486 REV F Operations Manual, HPA2, Compact Outdoor SSPA
2.9.3 Installation
1. Locate the mounting studs on the bottom of the Compact Outdoor SSPA unit. Using a ½”
bolt, two flat washers, and a ½” nut, firmly bolt one mounting bracket to each mounting
stud, as shown in Figure 2-10. Be sure each bracket is vertical, and the top flange of the
mounting bracket points away from the unit.
2. Place one piece of Uni-Strut (open channel up) at each end of the CO unit, across the
flanges of the mounting brackets, lining up the holes. For each All-Thread stud, run on a
½” nut approximately 1” from the rod end. Slip on a lock washer, and thread the short
end of the stud through the Uni-strut and mounting flange. Secure firmly in place with a
flat washer and nut. The unit should now look as shown in Figure 2-11.
Figure 2-10: Bolt Mounting Bracket to Unit
Figure 2-11: Unit Ready for Boom Installation