Filter
Top Products
-39-
PLAYBACK
■ Basic Playback
The recorder has the following two basic playback func-
tions.
Playback/Reverse Playback
Plays back the record recorded last in forward or
reverse mode.
Auto Forward/Auto Reverse Playback
Plays back all recorded records continuously in for-
ward or reverse mode.
1. Pressing the PLAY button will play back the
picture. For reverse playback, press the PLAY
button.
2. Pressing the PLAY button during forward
playback will start reverse playback from the picture
currently displayed. To change from reverse to for-
ward playback, press the PLAY button again.
3. To toggle between playback and auto forward play-
back, press the SET button. Each operation of the
SET button will toggle between these two modes.
Proceed in the same way to toggle between reverse
playback and auto reverse playback.
4. Pressing the PAUSE button during playback or
reverse playback will pause playback.
5. To resume playback, press the PLAY or
PLAY button.
6. To stop playback or reverse playback, press the
STOP button.
■ Playback Select Function
This function lets you select the playback picture when
the two cameras or a video multiplexer are connected to
the Disc Recorder.
1. While the recorder is paused in playback, press the
(–) or (+) button repeatedly.
The input channels or camera ID numbers are dis-
played in the lower right corner of the monitor
screen as shown below.
012345aMA PLAY P :CAPTURE RATE
AUG 1.98 14:15:05 (A)
T/L MODE
–
FORMAT
+
2. Press the PLAY BACK SELECT button. The pic-
ture selected in step 1 by pressing the (–) or (+) but-
ton is played back in the mode paused with the
PAUSE button.
3. To release this mode, select AB or ALL by pressing
the (–) or (+) button, then press the PLAY BACK
SELECT button.
Note: A camera ID specified to select the playback
picture may not take effect until the second pic-
ture displayed.
■ Jump or Skip Record Playback
This function allows you to jump to a previous or next
record during playback. There are two modes avail-
able.
One jumps one record forward (or backward) from the
currently selected record. The other skips the number
of records specified in the setup menu.
After jumping or skipping records, the recorder resumes
playback in the mode paused with the PAUSE button.
● Jump Record Function
Press the (or ) button during the playback.
(or ) is displayed on the lower center of
the monitor screen, and moves one record forward
(or backward) from the record presently selected.
● Skip Record Function
Press the (or ) button for about 2 seconds
during playback.
(or ) is displayed in the lower center of the
monitor screen. Playback skips forward or back-
ward from the record currently selected by the
number of records specified in the setup.