Filter
Top Products
-19-
● Series Recording Setup
This item lets you designate the master and the slave
recorder when more than one Disc Recorder is used for
series recording.
1. Move the cursor to the SERIES REC parameter in
the SYSTEM menu by pressing the or but-
ton.
2. Select either MASTER or SLAVE by pressing the
or button.
MASTER: Designates a master recorder.
SLAVE 1-15: Designates a slave recorder.
Set the SLAVE 1 parameter for the sec-
ond recorder. In Alternate Time Lapse
Recording, you can record in sequence
on up to 16 connected recorders. When
three or more recorders are connected,
set SLAVE 2 for the the third recorder,
SLAVE 3 for the fourth, and so on up to
SLAVE 15. The SLAVE 2 - 15 recorders
are activated in numerical sequence.
The default setting is MASTER.
● Series Recording Output Setup
This item lets you set the signal type for the SERIES
REC OUT terminal on the Terminal Board located on the
rear of the Disc Recorder.
1. Move the cursor to the SERIES REC OUT parameter
in the SYSTEM menu by pressing the or
button.
2. Select either OPEN or CLOSE by pressing the
or button.
OPEN: Supplies the series recording output sig-
nal when the Disc Recorder is not in
recording mode.
Select this parameter for Alternate Alarm
Recording (page 37).
CLOSE: Supplies the series recording output sig-
nal when the Disc Recorder is in record-
ing mode.
Select this parameter for Alternate Time
Lapse Recording (page 37).
The default setting is CLOSE.
● Disc LED Function Setup
This item lets you specify the conditions for output of the
signal from the DISC LED MONITOR terminal on the
Terminal Board located on the rear of the Disc
Recorder. See page 10.
1. Move the cursor to the DISC LED FUNCTION para-
meter in the SYSTEM menu by pressing the or
button.
2. Select either SPACE or FULL by pressing the or
button.
SPACE: Signal is output when disc space is
running low (interlocks the signal with
the DISC indicator on the Disc
Recorder’s front panel). See page 3.
FULL: Signal is output when the disc is full.
The default setting is FULL.
● Buzzer Setup
This item lets you enable or disable the buzzer sound
accompanying operation of the Disc Recorder’s but-
tons.
1. Move the cursor to the BUZZER parameter in the
SYSTEM menu by pressing the or button.
2. Select either ON or OFF by pressing the or
button.
ON: Enables buzzer.
OFF: Disables buzzer.
The default setting is ON.
■ Recording Mode Menu
This menu lets you set the recording mode for
recording on the DVD-RAM disk. Select MODE 1 or
MODE 2 and set up the items as shown below.
MODE 1: This is the normal recording mode. Make
sure to set up all items.
MODE 2: Available with Program Recording only.
(See pagees 27 and 38.)
MAIN
SET UP ENABLE
SYSTEM *
REC MODE MODE1 *
MODE2 *
ALARM RECORD *
SEARCH/PLAY *
SYSTEM INFO *
Panasonic AV Disc Recorder V1.0R00
In the MAIN menu, move the cursor to the REC
MODE parameter and select MODE 1 or MODE 2 by
pressing the or button, then press the SET
button.