Filter
Top Products
-23-
● Recording Pattern
When the CAMERA INPUT parameter in the VIDEO
INPUT menu is set to A+B (CAMERA ID OFF), this
item lets you select recording of pre and post-
frames from input A and/or B.
1. Move the cursor to the REC PATTERN parame-
ter in the TIME LAPSE menu by pressing the
or button.
2. Select the desired recording input by pressing
the or button as shown below.
Pre Frame
Quantity
Zero
AA
AB
BB
–
–
–
A
A and B
B
AA/BB
AA/AB
BB/AA
BB/AB
AB/AA
AB/BB
AB/AB
More then
one
A
A
B
B
A and B
A and B
A and B
B
A and B
A
A and B
A
B
A and B
Pre Frame
Recorded
Post Frame
Recorded
Parameter
● Sensor Record
This item lets you select whether to record sensor input
from the SENSOR IN terminal on the rear of the Disc
Recorder according to the same pattern as set for alarm
recording or according to a different pattern.
1. Move the cursor to the SENSOR REC parameter in
the TIME LAPSE menu by pressing the or
button.
2. Select either pattern by pressing the or but-
ton.
SAME AS ALARM: Same recording pattern as for
alarm activation
DIFF FROM ALARM: Different recording pattern
than for alarm activation
The default setting is SAME AS ALARM.
3. If you select DIFF FROM ALARM in step 2 above,
you need to change the following parameters.
• Pre Frames
This item lets you select the number of pre-frames
recorded when there is sensor input from the SEN-
SOR IN terminal.
The maximum number of pre-frames is set with the
PRE FRAMES parameter above.
1. Move the cursor to the PRE FRAMES parameter
in the TIME LAPSE menu by pressing the or
button.
2. Select the number of pre-frames to be recorded
by pressing the or button.
2. Select TIME LAPSE
*
by pressing the or
button, then press the SET button. The TIME LAPSE
menu shown below appears on the monitor screen.
TIME LAPSE(MODE*)
CAPTURE RATE 0.20 sec
(RECORD TIME 1h35m)
PRE FRAMES 0
REC PATTERN -
SENSOR REC SAME AS ALARM
PRE FRAMES -
POST REC PATTERN -
MANUAL REC ALARM OFF
RECORD PARTITION 80
AUTO START OFF
3. Move the cursor to the parameters by pressing the
or button, then select the desired mode by
pressing the or button.
● Capture Rate
This item lets you specify the interval (seconds) for
recording of multiple freeze pictures.
1. Move the cursor to the CAPTURE RATE parameter
in the TIME LAPSE menu by pressing the or
button.
2. Select the desired interval by pressing the or
button.
The following intervals are available depending on
the selected pixel number.
720
*
480: 0.07, 0.10, 0.17, 0.20, 0.33, 0.50, 1.0,
2.0, ····· 30.0
720
*
240: 0.03, 0.07, 0.10, 0.17, 0.20, 0.33, 0.50,
1.0, 2.0, ····· 30.0
The default setting is 0.20 sec.
● Pre Frames
This item lets you select the number of pre-frames
recorded in standby for manual recording or prior to
alarm input in alarm recording mode.
1. Move the cursor to the PRE FRAMES parameter
in the TIME LAPSE menu by pressing the or
button.
2. Select the desired number of frames by press-
ing the or button.
The default setting is 0.