Filter
Top Products
-27-
1. Move the cursor to the PROGRAM TIMER parameter
in the ALARM RECORD menu by pressing the
or button.
2. Select either ON or OFF by pressing the or
button.
ON : Enables Program Timer recording.
To program the timer, you need to make the
necessary settings in the associated sub-
menu. Refer to the Program Timer menu
shown below for details.
OFF: Disables Program Timer recording.
Note: ON mode is available only when the AUTO
START parameter in the Time Lapse Recording
Menu is set to OFF.
The default setting is OFF.
● Program Timer Menu
This menu lets you select either of two Program Timer
recording patterns for each day of the week.
1. Move the cursor to the PROGRAM TIMER parameter
in the ALARM RECORD menu by pressing the
or button.
2. Select ON by pressing the or button, then
press the SET button. The PROGRAM TIMER menu
shown below appears on the monitor screen.
PROGRAM TIMER
Sun PROGl *
Mon PROGl *
Tue PROGl * PROGl START END
Wed PROGl * MODE1 08:00-20:00
Thu PROGl * MODE2 20:00-08:00
Fri PROGl *
Sat PROGl * PROG2 START END
MODE1 00:00-24:00
MODE2 --:-----:--
1. Move the cursor to the TIMER DURATION parame-
ter in the ALARM RECORD menu by pressing the
or button.
2. Select an alarm duration between 1 second and 5
minutes as shown below by pressing the or
button.
1 sec - 30 sec, 1 min, 2 min, 3 min, 4 min, 5 min
The default setting is 2 sec.
● Alarm Buzzer Setup
This item lets you enable or disable the buzzer sound in
response to alarm input.
1. Move the cursor to the BUZZER parameter in the
ALARM RECORD menu by pressing the or
button.
2. Select ON or OFF by pressing the or button.
ON: Buzzer enabled.
OFF: Buzzer disabled.
The default setting is OFF.
● Alarm Label Setup
Refer to Label Setup on page 30 for details.
● Sensor Label Setup
Refer to Label Setup on page 30 for details.
● Delay Time Setup
This item lets you select the delay between input of the
alarm or sensor signal and the start of recording.
1. Move the cursor to the DELAY TIME parameter in
the ALARM RECORD menu by pressing the or
button.
2. Select the desired time as shown below by pressing
the or button.
OFF, 0.05 sec, 0.10 sec, 0.30 sec, 0.50 sec, 1 sec,
2 sec ····· 10 sec
The default setting is 0.05 sec.
● Program Timer Setup
This item lets you enable or disable the Program Timer
function.
3. Move the cursor to the desired day by pressing the
or button, then select OFF or PROG 1 or 2
by pressing the or button.
PROG1: Selects the recording pattern stored in
PROG1.
PROG2: Selects the recording pattern stored in
PROG2.
OFF: Disables Program Timer recording.