Panasonic WJ-DR200 Stereo Receiver User Manual


 
-10-
Terminal Board
The Terminal Board has the following functions. Make
connections to these terminals as needed for operating
your system. GND terminal is common ground for all
terminals.
GND
SENSOR IN
ALARM IN
ALARM RESET IN
SERIES REC IN
TIME ADJUST IN
GND
ALARM OUT
ALARM RECOVER OUT
ALARM REC
REC
DISC
BUZZER OUT
SYSTEM ERROR OUT
THERMAL ERROR OUT
TIME ADJUST OUT
SERIES REC OUT
LED
MONITOR
Input Terminals
SENSOR IN: Connects the input signal to start
recording in Alarm Recording mode.
(In Time Lapse mode, recording is enabled
while this signal is input.)
The ALARM indicator on the front panel of the
Disc Recorder does not light in response to this
recording input.
(Any alarm output functions are disabled.)
ALARM IN: Connects the input signal to start
recording in Alarm Recording mode.
(In Time Lapse mode, recording is enabled
while this signal is input.)
The Alarm indicator on the front panel of the
Disc Recorder lights in response to this record-
ing input. The buzzer sounds if the buzzer func-
tion was selected in the Setup menu.
ALARM RESET IN: Connects the alarm and/or
buzzer reset input when an alarm has been acti-
vated.
SERIES REC IN: Connects an input signal to
enable recording on two series-connected Disc
Recorders.
TIME ADJUST IN: Connects a time adjust input
from an external source to synchronize the Disc
Recorder’s internal clock. When this input is
detected, the time is adjusted to an accuracy of
±30 seconds.
Output Terminals
ALARM OUT: Sends an alarm signal in response to
an alarm input.
ALARM RECOVER OUT: Sends an alarm recover
signal in response to the alarm reset signal
received when the ALARM RESET button is
pressed, or when recording in Alarm Recording
mode is terminated.
ALARM REC: Outputs an alarm recording signal
while the Disc Recorder is operated in Alarm
Recording mode.
REC: Outputs an image recording signal while the
Disc Recorder is recording pictures. The signal
is interlocked with lighting of the REC indicator
on the Disc Recorder’s front panel.
DISC: Sends a signal when DVD-RAM disc space is
running low. The signal’s output parameters
can be changed from the Setup menu.
BUZZER OUT: Outputs a buzzer signal interlocked
with the Disc Recorder’s buzzer.
SYSTEM ERROR OUT: Outputs an error signal
when a fatal system error occurs in the Disc
Recorder.
THERMAL ERROR OUT: Outputs a signal when a
temperature rise is detected in the Disc
Recorder.
TIME ADJUST OUT: Sends a time adjust signal
used to slave the internal clocks of connected
equipment to that of the Disc Recorder. Output
as a 1-second pulse every day at 9:00 AM.
SERIES REC OUT: Outputs a signal that enables
recording on two series-connected Disc
Recorders.