Filter
Top Products
48
Synchronized Recording
This operation is only possible while the receiver is ready for the
main room operations.
Synchronized recording means the cassette deck (or MD recorder)
starts recording as soon as a CD or a record begins playing.
• When using a CD recorder for synchronized recording, refer to the
manual supplied with it.
To use synchronized recording, follow these steps:
1. Put a tape in the cassette deck (or an MD in the
MD recorder), and a disc in the CD player (or a
record on the turntable).
2. Press the record (¶) button and the pause (8)
button on the cassette deck (or MD recorder) at
the same time.
This puts the cassette deck (or MD recorder) into recording
pause.
If you do not press the record (¶) button and pause (8) button at
the same time, the synchronized recording feature will not
operate.
3. Press the play (3) button on the CD player or on
the turntable.
The main room source changes on the receiver, and as soon as
play starts, the cassette deck (or MD recorder) starts recording.
When the play ends, the cassette deck (or MD recorder) enters
recording pause, and stops about 4 seconds later.
Notes:
• During synchronized recording;
– the selected main room source cannot be changed. (You can
change the sub-room source.)
– If the same source is selected both for the main room and the
sub-room, operating the sub-room source will affect the
recording.
• The COMPU LINK remote control system may not operate properly
during synchronized recording;
– If the power of any component is shut off during synchronized
recording.
– If the main room sound is turned off by pressing MAIN ROOM
ON/OFF.
In this case, you must start again from the beginning.
Automatic Power Off (Standby):
• When you turn off the receiver by pressing POWER, the
connected components will turn off (standby).
• When you turn off the main room sound by pressing MAIN
ROOM ON/OFF, the selected main room source component
turns off (unless the same component is selected as the sub-room
source).
– If the SUB ROOM ON/OFF lamp on the front panel is lit green,
the
main room source will stop playing, but will not turn off.
• When you turn off the sub-room source by pressing SUB
ROOM ON/OFF, the selected sub-room source component turns
off (unless the same component is selected as the main room
source).
– If the MAIN ROOM ON/OFF lamp on the front panel is lit red,
the
main room source will stop playing, but will not turn off.
EN42_53.RX-9000V[J]/f 00.2.15, 3:23 PM48