Filter
Top Products
10
Setting Up the RF Rod Antenna
The RF rod antenna is supplied with this receiver to allow you to use
the Multi-room function.
With the RF rod antenna, you can operate the receiver at a distance
of up to 50 feet (15 m) using the remote control. However, If the
antenna cannot receive signals stably, you cannot operate the
receiver correctly.
• The signal-reachable distance may differ depending on the
operating conditions and circumstances.
The remote control supplied with this receiver can transmit both RF
(Radio Frequency) signal and IR (infrared) signal at the same time
to operate the receiver.
The RF rod antenna can receive the RF signals emitted from the
remote control. This means that you do not have to aim the remote
control at the remote sensor on the receiver when operating the
receiver.
• Without the RF rod antenna connected, you can operate the
receiver with the remote control, aiming the remote control
directly toward the remote sensor on the receiver.
To set up the RF rod antenna
1. Insert the RF rod antenna to the RF REMOTE
ANTENNA terminal.
2. Rotate the fixing nut to attach the RF rod
antenna firmly.
Setting Up the IR Signal Transmitter
The IR signal transmitter can transmit the IR signals.
It allows you to use the AV COMPULINK system, and to operate
other manufacturers’ video components. Without the IR transmitter
connected, you can operate other components with the remote
control, aiming the remote control directly toward the remote sensor
on the target components. However, the IR signal transmitter
reduces the possibility of malfunction.
• The IR signal transmitter may not operate the target components
depending on the operating conditions and circumstances —
including the aiming angle and direction of the IR signal
transmitter toward the remote sensors of the target components.
If this occurs, changing its aiming angle and direction toward the
remote sensors may solve the problem.
To set up the IR signal transmitter
1. Find the place where you attach the IR signal
transmitter.
• Place it where the signal can reach the remote sensor of the
target components directly (in the line-of-sight).
• If the cord length of the IR signal transmitter is not long
enough, use an extension cord (separately purchased).
2. Attach the double-sided adhesive tape
(supplied) to the IR signal transmitter.
3. Connect the plug of the transmitter to the IR
OUT jack of the receiver and place the
transmitter.
RF REMOTE
ANTENNA
IR OUT
RF REMOTE
ANTENNA
IR OUT
IR signal transmitter
Double-sided
adhesive tape
IR OUT
ANTENNA
RF REMOTE
Less than
10 feet
(3 m
)
At an angle of
approx. 60°
Horizontally: 60˚
Signal-emitting angle of the transmitter
Vertically: 60˚
15°
45°
30°
30°
EN01_11.RX-9000V[J]/f 00.2.15, 2:45 PM10