Filter
Top Products
18
Muting the Main Room Sound
From the remote control ONLY:
Press MUTING to mute the sound through all
speakers in the main room and headphones
connected.
“MUTING” appears on the display and the volume turns off (the
volume level indicator goes off).
To restore the sound, press MUTING again so that “OFF” appears
on the display.
• Turning MASTER VOLUME on the front panel or pressing
VOLUME +/– on the remote control also restores the sound.
Reinforcing the Bass
Human ears are not sensitive to bass at low volume. To compensate
for this, the bass boost function automatically boost the bass level as
you lower the volume.
On the front panel ONLY:
Press BASS BOOST (SOURCE NAME)
briefly to select the bass boost function.
• Each time you press the button, the bass boost
function turns on (“BASSBOOST ON”) and
off (“BASSBOOST OFF”).
– Select “BASSBOOST ON” to activate the bass boost function.
The BASS BOOST indicator lights up on the display.
– Select “BASSBOOST OFF” to cancel it.
The indicator goes off.
Note:
This function affects the front speaker sounds in the main room only.
Attenuating the Input Signal
When the input level of the playing source is too high, the sounds
will be distorted. If this happens, you need to attenuate the input
signal level to prevent the sound distortion.
On the front panel ONLY:
Press and hold INPUT ATT. (SOUND
SELECT) so that the
INPUT ATT
indicator
lights up on the display.
• Each time you press and hold the button, the
Input Attenuator mode turns on (“INPUT ATT
ON”) or off (“INPUT NORMAL”).
Notes:
• This effect is applied to only the main room sources connected using
the analog terminals (except “DVD MULTI”).
• This function takes effect when the DSP mode is in use.
BASS BOOST
SOURCE NAME
SOUND SELECT
INPUT ATT.
Adjusting the Subwoofer Output Level
You can adjust the subwoofer output level if you have selected
“YES” for the “SUBWOOFER” (see page 23).
Once it has been adjusted, the receiver memorizes the adjustment.
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
• When the front speakers are all deactivated, the subwoofer level
cannot be adjusted.
On the front panel:
1. Press BALANCE/SURROUND
ADJUST repeatedly until
“SUBWFR LEVEL” appears on
the display.
The display changes to show the current setting.
2. Turn MULTI JOG to adjust the
subwoofer output level (–10 dB to
+10 dB).
From the remote control:
1. Press SOUND.
The 10 keys are activated for sound adjustments.
2. Press SUBWOOFER –/+ to adjust
the subwoofer output level (–10 dB
to +10 dB).
Note:
This function is applied only to the main room sources.
BALANCE/SURROUND
ADJUST
MULTI JOG
SUBWOOFER
0
+10
100+FM MODE
SOUND
MUTING
EN12_22.RX-9000V[J]/f 00.2.18, 2:25 PM18