Filter
Top Products
47
COMPU LINK Remote Control System
The COMPU LINK remote control system allows you to operate JVC audio components through this receiver.
This remote control system allows you to use four functions listed
below.
Remote Control through the Remote Sensor on the
Receiver
You can control the connected audio components through the
receiver using this remote control. For details, see pages 57 and 58.
Automatic Source Selection
• When you press the play (
33
33
3) button on a connected component or
on its own remote control, the receiver automatically turns on and
changes the main room source to the component.
– If the receiver is already turned on and the SUB ROOM
CONTROL lamp on the front panel is lit green, the receiver
changes the
sub-room source to the component.
• When you press PLAY on the remote control supplied with this
receiver, the receiver automatically turns on and changes the main
room source or sub-room source (depending on the multi-room
operation selector setting on the remote control) to the target
component.
• When you select a new source on the receiver or on the remote
control supplied with this receiver either for
the main room or
sub-room, the newly selected component begins playing
immediately, and the previously selected source continues playing
without sound for a few seconds.
Automatic Power On/Off (Standby): only possible
with the COMPU LINK-3 and COMPU LINK--4
connection
Automatic Power On:
• When you turn on the receiver by pressing POWER on the
front panel or AUDIO POWER ON on the remote control
(with the multi-room operation selector set to “MAIN
ROOM”):
OR
When you turn on the main room sound by pressing MAIN
ROOM ON/OFF while the receiver is turned on:
\ The MAIN ROOM ON/OFF lamp on the front panel lights
red, and one of the connected components will turn on
automatically, depending on which component has been
previously selected as the
main room source.
• When you turn on the receiver by pressing AUDIO POWER
ON on the remote control (with the multi-room operation
selector set to “SUB ROOM”):
OR
When you turn on the sub-room sound by pressing SUB
ROOM ON/OFF while the receiver is turned on:
\ The SUB ROOM ON/OFF lamp on the front panel lights
green, and one of the connected components will turn on
automatically, depending on which component has been
previously selected as the
sub-room source.
Continued to the next page.
To use this remote control system, you need to connect JVC audio
components through the COMPU LINK jacks (see below) in
addition to the connections using cables with RCA pin plugs (see
pages 6 and 7).
• Make sure that the AC power cords of these components are
unplugged before connection. Plug the AC power cords only after
all connections are complete.
Notes:
• There are four versions of COMPU LINK remote control system.
This receiver is equipped with the fourth version — COMPU LINK-
4. This version is created by adding systematic operations with the
CD recorder to the previous version — COMPU LINK-3.
• If your audio component has two COMPU LINK jacks, you can use
either one. If it has only one COMPU LINK jack, connect it so that it
is the last item in the series of components. (For example, the
turntable or CD player in the diagram above.)
• To operate the cassette deck or MD recorder using the COMPU
LINK remote control system, set the source name correctly. (See
page 23.)
• Refer also to the manuals supplied with your audio components.
COMPU LINK – 4
(SYNCHRO)
CD recorder
CD player
Turntable
Cassette deck
or
MD recorder
EN42_53.RX-9000V[J]/f 00.2.15, 3:23 PM47