Filter
Top Products
28
Storing the Basic Settings and
Adjustments — One Touch Operation
JVC’s One Touch Operation function is used to assign and store
different sound settings for each different main room source. By
using this function, you do not have to change the settings every
time you change the main room source. The stored settings for the
newly selected source are automatically recalled.
The following can be stored for each source:
• Volume level (see page 17)
• Bass boost (see page 18)
• Input attenuator mode (see page 18)
• Subwoofer output level (see page 18)
• Balance (see page 19)
• SEA modes (see page 31)
• DSP modes (see page 32)
– Surround mode
– DAP mode
– 3D-PHONIC mode
• DVD MULTI playback mode (see page 41)
On the front panel ONLY:
To store the sound settings
1. Press ONE TOUCH OPERATION.
The ONE TOUCH OPERATION lamp lights
up, then the previously memorized settings
are recalled.
2. Adjust the sound using the functions listed above.
The newly adjusted settings are memorized.
To recall the sound settings
With the ONE TOUCH OPERATION lamp lit, the settings for the
currently selected source are recalled when the source is selected.
To cancel the One Touch Operation function
Press ONE TOUCH OPERATION so that the lamp goes off.
(Even though the One Touch Operation function is canceled, the
recalled sound effects remain active.)
Notes:
• This function cannot be used for the sub-room sources.
• If the source is FM or AM, you can assign a different setting for
each band.
• The DSP modes and DVD MULTI playback mode cannot be used at
the same time.
ONE TOUCH OPERATION
––––––––––––––– MEMO –––––––––––––––
Use this column to write down your basic settings for future
reference.
EN23_30.RX-9000V[J]/f 00.2.18, 2:27 PM28