Filter
Top Products
41
Editing Recorded MDs
7 Press YES (or ./> on the deck).
The deck starts recording over the specified
portion of the original track. “S.F Edit:
XX%” appears to show the recording
progress while the portion is being recorded
over. When the process finishes,
“Complete!!” appears in the display for a few
seconds.
To cancel the operation
Press MENU/NO or x (or x/Z on the deck) in
steps 1 to 6 above. After you press YES (or
./> on the deck) in step 7, you can’t cancel
the operation.
Notes
• Do not disconnect the AC power adaptor or move
the deck while the recording is in progress. This
may damage the recording data preventing
recording from being performed properly.
• You can’t change the level of tracks recorded in
LP2 or LP4 mode.
• Do not use an MD that is damaged or dirty. This
may prevent the track from being recorded
properly.
• Repeated changes of the track level using the S.F
Edit function results in poor sound quality.
• Once the track level has been changed, the track
level will not return to the exact original level, even
if you attempt to return it by performing the S.F
Edit function again. Note also that you cannot undo
the S.F Edit function.