Filter
Top Products
20
• Track marking may not occur in the following
tracks:
— Tracks that are less than 4 seconds long (in
stereo, monaural, or LP2 stereo mode).
— Tracks that are less than 8 seconds long (in LP4
stereo mode).
• When recording from a component connected to the
LINE (ANALOG) IN jacks with “T.Mark Off”
selected or when recording from a DAT deck or
DBS tuner connected to the DIGITAL (OPTICAL)
IN connector, the entire material may be recorded
as a single track.
• When recording from a DAT deck or DBS tuner
connected to the DIGITAL (OPTICAL) IN
connector, the deck will mark a track number
whenever the sampling frequency of the input
signal changes, regardless of the track marking
parameter setting (“T.Mark LSync” or “ T.Mark
Off”).
z
You can mark track numbers
even after recording has finished
See “Dividing Tracks” on page 31.
Notes
• If you turn off the deck or disconnect the AC power
adaptor, the deck will store the last settings
(“T.Mark LSync” or “ T.Mark Off” and the trigger
level) and apply them the next time you turn on the
deck.
• The entire contents of a radio broadcast or a cassette
may be recorded as a single track if it contains
static.
Synchro-recording With
the Audio Component of
Your Choice
(Music Synchro-recording)
The Music Synchro-recording allows you to
automatically synchronize recording on the MD
deck with the playing of the selected program
source. The Track Marking function, however,
will differ according to the program source. For
details, see “Marking Track Numbers While
Recording” on page 18.
?/1
Z
N
Xx
.>
z
mM
–
+
g
MUSIC SYNC
1 Do steps 1 to 5 of “Recording on an
MD” on pages 12 and 13.
2 Press MUSIC SYNC.
The deck changes to recording pause.
3 Start playing the program source.
Recording starts automatically.
To stop Music Synchro-recording
Press x (or x/Z on the deck).
Note
During Music Synchro-recording, Smart Space and
Auto Cut will operate regardless of their setting
(“S.Space On” or “S.Space Off”) (page 17).
Marking Track Numbers While
Recording (continued)