Filter
Top Products
10
Notes
• Insert plugs into jacks firmly. Loose connections
may be a cause of noise or malfunction in the MD
deck.
• When connecting an optical digital cable, take the
caps off the connectors and insert the cable plugs
straight in the jacks until you hear a click.
When a plug is not completely inserted, “C71” and
“Din Unlock” may alternate in the display.
Do not bend or tie the optical cable.
Connecting the MD deck to
active speakers, etc.
Required connecting cord
Audio connecting cord (stereo mini-plug × 1 y
stereo mini-plug × 1) (supplied) or audio connecting
cord (stereo mini-plug× 1 y pin-plug × 2)
The example below shows the MD deck connected to
active speakers with an audio connecting cord (stereo
mini-plug × 1 y stereo mini-plug × 1) (supplied).
Ç
IN
LINE
ANALOG
(VARIABLE)
IN OUT
l : Signal flow
or
Connecting the MD deck to a
system stereo or an amplifier
By connecting the MD deck to a system stereo or to
an amplifier with optical digital input jacks, you can
enjoy listening to MDs on the speakers connected to
the system stereo or the amplifier.
Required connecting cord
Optical digital cable (supplied)
z
You can change the output level
of the ANALOG OUT jacks
1While the deck is stopped, press MENU/NO twice
to display “Setup Menu.”
2Press ./> repeatedly (or turn ./> on
the deck) until “Aout” appears, then press YES (or
./> on the deck).
3Press ./> repeatedly (or turn ./> on
the deck) to change the output level, then press YES
(or ./> on the deck).
4Press MENU/NO.
You can also change the level with LEVEL +/–. In
such a case, note that the output level of the PHONES
jack will change with the output level of the
ANALOG OUT jacks (page 21).
Connecting the AC power
adaptor
Connect the AC power adaptor to the DC IN 9 V jack
on the MD deck and to a wall outlet.
Notes
• Do not connect the AC power adaptor to a switched
outlet.
• Use only the supplied AC power adaptor. Do not
use any other AC power adaptor.
Polarity of the plug
Hooking Up (continued)
Active speakers, etc.MDS-PC3