Filter
Top Products
21
Playing MDs
Playing MDs
Playing an MD
The operations for normal play are explained
below.
?/1
Z
N
Xx
.>
z
mM
–
+
g
./>
N
Z
?/1
X
x
LEVEL +/–
1 Turn on the amplifier and select MD on
the amplifier.
2 Press ?/1 to turn on the deck.
The switch indicator on the deck turns off.
3 Insert an MD (page 4).
4 If necessary, press ./>
repeatedly (or turn ./> on the
deck) to locate the track you want to
start playing from.
If you want to play from the first track, go to
step 5.
5 Press N (or NX on the deck).
The deck starts to play.
6 Adjust the volume on the amplifier.
Resume play after
pausing
N or X (or NX on the
deck)
Locate a succeeding
track
> repeatedly (or turn
./> clockwise on the
deck)
Locate the beginning
of the current track
or a preceding track
. repeatedly (or turn
./> counterclockwise
on the deck)
Eject the MD EJECT Z (or x/Z on the
deck) after stopping play
z
When you play an MD recorded in
LP2 or LP4 stereo mode
“LP2” or “LP4” appears in the display when you
press N (or NX on the deck).
z
Using headphones
Connect headphones to the PHONES jack on the rear
of the deck. You can adjust the volume of the
headphones with LEVEL +/–. The output level of the
ANALOG OUT jacks changes with the volume of the
headphones, from –
dB to 0 dB. This output is
factory set at – 14.0 dB. When recording from the
deck to another audio component, be sure to set the
output level to 0 dB (“ATT” turns off in the display).
Operations you may want to do
during play
To Press
Stop play x (or x/Z on the deck)
Pause play X (or NX on the deck)
Recording on MDs/Playing MDs