Filter
Top Products
13
Recording on MDs
5 If necessary, locate the point on the MD
to start recording from.
If you want to record on a new MD or start
recording from the end of the recorded
portion, go to step 6.
To record over from the
beginning of an existing MD
track
Press ./> repeatedly (or turn
./> on the deck) until the number of
the track to be recorded over appears.
To record over from the middle
of an MD track
Press ./> repeatedly (or turn
./> on the deck) until the number of
the track to be recorded over appears, then
press N (or NX on the deck) to start
playback. Press X (or NX on the deck),
then z at the point you want to start
recording from.
6 Press z.
The deck changes to recording pause.
7 If necessary, adjust the recording level.
For details, see “Adjusting the Recording
Level” on page 14.
8 Press N or X (or NX on the deck).
Recording starts.
9 Start playing the program source.
When you pause recording
The track number increases by one. For example,
if you paused recording while recording track 4,
the track number will be 5 when you resume
recording.
To prevent accidental erasure of
the recorded material
To make it impossible to record on an MD, slide
the record-protect tab in the direction of the arrow
(see illustration below) to open the slot. To enable
recording, close the slot.
z
To play the tracks you just
recorded
Press N (or NX on the deck) immediately after
stopping recording.
The deck starts to play from the first track of the
material just recorded.
Resume recording
after pausing
N or X (or NX on the
deck)
Eject the MD EJECT Z (or x/Z on the
deck) after stopping recording
Slide in the direction
of arrow
Bottom side
of the MD
Record-protect tab
Operations you may want to do
during recording
To Press
Stop recording x (or x/Z on the deck)
Pause recording X (or NX on the deck)
continued