Filter
Top Products
35
Editing Recorded MDs
Naming Tracks or MDs
You can enter a name for a recorded MD as well
as for individual tracks. Names can consist of
uppercase and lowercase letters, numbers, and
symbols. A total number of 1,700 characters can
be stored for all the names on the MD.
m/M
./>
?/1
Z
N
Xx
.>
z
mM
–
+
g
YES
CLEAR
MENU/NO
DISPLAY
Note
If you name a track while it is being recorded, be sure
to finish the naming operation before the track ends.
If the track ends before you finish, the entered
character data will be discarded and the track will
remain unnamed. Also, you can’t name tracks while
the deck is recording over existing material.
Naming a track or MD
1 While the deck is stopped, playing, or
paused, press MENU/NO to display
“Edit Menu.” If you want to name a
track that is currently being recorded,
go to step 3.
2 Press ./> repeatedly (or turn
./> on the deck) until “Name ?”
appears, and then press YES (or ./
> on the deck).
3 Press ./> repeatedly (or turn
./> on the deck) until “Nm In ?”
appears, and then press YES (or ./
> on the deck).
While the deck is recording, a flashing cursor
appears in the display and you can enter a
name for the track currently being recorded.
In this case, go to step 5.
4 Press ./> repeatedly (or turn
./> on the deck) until the
number of the track (when naming a
track) or “Disc” (when naming the MD)
flashes, then press YES (or ./>
on the deck).
The cursor begins to flash in the display and
it becomes possible to type in the name. In
step 4, when the track number that you select
begins to flash, the track will automatically
begin to play, allowing you hear the track as
you name it.
5 Press DISPLAY repeatedly to select the
character type.
To select Press repeatedly until
Uppercase letters “A” appears in the
display
Lowercase letters “a” appears in the display
Numbers or symbols* “0” appears in the display
* The following symbols can be selected:
' – / , . ( ) : ! ? & + < > _ = " ; # $ % @ `
A
To enter a space
Press M while the cursor is flashing. You
cannot enter a space at the beginning of the
name.
6 Press ./> repeatedly (or turn
./> on the deck) to select a
character.
The character flashes.
D
To change a selected character
Repeat step 5 and 6.
continued