Filter
Top Products
E-43
On-screen Error Messages
The following messages appear on the TV screen in case of an error during operation.
Error message Possible Error Suggested Solution
Cannot play. The disc cannot be played back with this Unit.
●
Check the disc, and load it correctly.
●
Incompatible disc.
If you load a disc which cannot be played with this Unit (i.e. a scratched
disc), or if you load a disc upside down, this message will appear, and
the disc tray will automatically pop out.
●
Occurs if the loaded disc cannot be played because it is a non-
standard disc or scratched, etc.
●
Remove the disc.
●
Cannot operate. Occurs if an operation is incorrect.
●
—
This USB memory is not formatted properly. Please format the
memory in USB memory management.
Occurs if there is a formatting error.
Occurs if the USB memory is not formatted with FAT 32/16.
●
●
Format the USB memory again.
Format the USB memory with your PC.
●
●
The Connected USB Memory cannot be used. It should be compliant
with USB 2.0
Occurs if USB memory not compliant with USB 2.0 High Speed
(480Mbit/s) is used (i.e. USB 1.0/USB 1.1).
●
Connect USB 2.0 High Speed (480Mbit/s) compliant USB memory.
●
As part of our policy of continuous improvement, SHARP reserves
the right to make design and specication changes for product
improvement without prior notice. The performance specication
gures indicated are nominal values of production units. There may
be some deviations from these values in individual units.
General■
Power source
AC 220 - 240 V ~ 50/60 Hz
Power consumption
Power on: 52 W
Power stand-by: 0.5 W (*)
Dimensions
Width: 215 mm (8 - 1/2”)
Height: 96 mm (3 - 4/5”)
Depth: 335 mm (13 - 1/5”)
Weight
2.75 kg (6.06 lbs.)
Operating temperature
5°C to 35°C
Storage temperature
–20°C to 60°C
Operating humidity
10 % to 80 % (no condensation)
TV systems
PAL system/NTSC system (The system
recorded on the disc is output.)
( * ) This power consumption value is obtained when the demonstration
mode is cancelled in the power stand-by mode. Refer to page 10
to cancel the demonstration mode.
Amplier■
Output power
PMPO: 200 W
MPO: 100 W (50 W + 50 W)
(10% T.H.D.)
RMS: 100 W (50 W + 50 W)
(10% T.H.D.)
RMS: 66 W (33 W + 33 W)
(1% T.H.D.)
Output terminals
Speakers: 6 ohms
20Hz - 20kHz
Subwoofer Pre-out (audio signal):
200 mV/10 k ohms at 70 Hz
Video output: 1 Vp-p
Headphones: 16 - 50 ohms
(recommended: 32 ohms)
HDMI 19-pin standard connector (1080p
24Hz output)
HDMI™ (Deep Colour, x.v.Colour, Dolby
TrueHD, DTS-HD Master Audio | Essential)
Input terminals
Audio In (audio signal):
500 mV/47 k ohms
Line in (Analogue input):
500 mV/47 k ohms
Digital audio optical input terminal: Square
Optical terminal
Ethernet:
10BASE-T/100BASE-TX
BD player■
Type
Single disc multi-play disc unit
Signal readout
Non-contact, 3-beam
semiconductor laser pickup
Playable discs/
media formats
BD-ROM, BD-RE, BD-R,
DVD Video, DVD+RW/+R/-RW/-R (Video/
VR/AVCHD/JPEG le/MP3 le/DivX
(H.264/MKV) format),
Audio CD (CD-DA), CD-RW/R (CD-DA/
JPEG le/MP3 le format)
Region code
B or marked ALL for BD, 2 or marked ALL
for DVD
D/A converter
Multi bit D/A converter
Frequency response
20 - 20,000 Hz
Dynamic range
90 dB (1 kHz)
USB■
USB
USB 1 (5 V dc 500 mA
USB 2.0 High Speed (for Local Storage/
Software Update/JPEG/MP3 and DivX
(H.264/MKV) playback)
USB 2 (5 V dc 2.1 A)
(iPod/iPhone and iPad compatibility)
●
●
Tuner■
Frequency range
FM: 87.5 - 108 MHz
Preset
40 (FM station)
Speaker■
Type
2-way type speaker system
2.5 cm (1”) Dome-Tweeter
12 cm (4-3/4”) woofer
Maximum input
power
100 W
Rated input power
50 W
Impedance
6 ohms
Dimensions
Width: 148 mm (5-13/16”)
Height: 262 mm (10-5/16”)
Depth: 203.5 mm (8”)
Weight
2.50 kg (5.51 lbs.)/each
Specications