Sanyo PLC-WXL46 Home Theater System User Manual


  Open as PDF
of 68
 
54
Followthesestepstoreplacethelamp.
Lamp
ORDER REPLACEMENT LAMP
Replacementlampcanbeorderedthroughyourdealer.Whenorderingaprojectionlamp,givethefollowing
informationtothedealer.
●Model No. of your projector : PLC-WXL46
●Replacement Lamp Type No. : POA-LMP106POA-LMP106
(ServicePartsNo.6103323855)
Forcontinuedsafety,replacewithalampofthe
sametype.Donotdropalamportouchaglass
bulb!Theglasscanshatterandmaycauseinjury.
Allowtheprojectortocoolforatleast45minutes
beforeyouopentheLampcover.Theinsideofthe
projectorcanbecomeveryhot.
CAUTION
Screw
TurnofftheprojectorandunplugtheACpowercord.
Lettheprojectorcoolforatleast45minutes.
Loosenthetwoscrewsthatsecurethelamp.Liftthe
lampoutoftheprojectorbyusingthebuiltinhandle.
1
3
Replacethelampwithanewoneandsecureitwiththe
twoscrews.Makesurethatthelampissetproperly.
Putthelampcoverbackandsecureitwiththescrew.
4
Turntheprojectorover.Removethescrewthat
securesthelampcover,andthenopenthelampcover.
2
ConnecttheACpowercordtotheprojectorandturn
ontheprojector.
6
Reset the lamp replacement counter.
See“LampReplacementCounter”onthenextpage.
5
Handle
Screw
CAUTION
Screw
LampCover
Whentheprojectionlampoftheprojectorreachestheend
ofitslife,theLAMPREPLACEindicatoremitsayellowlight.
Ifthisindicatorlightsyellow,replacethelampwithanew
onepromptly.
Top Control
Lamp Replacement
WARNING:
TURNOFFTHEUVLAMPBEFORE
OPENINGTHELAMPCOVER
Thisindicator
turnsyellow
whenthe
projectionlamp
reachestheend
ofitslife.
Maintenance and Cleanin�
Note:
TheLampreplacementiconwillnotappear
whentheDisplayfunctionissetto“Off”(p.41),
during“Freeze”(p.23),or“Noshow”(p.24).
Lamp replacement icon
 previous next