Sanyo PLC-WXL46 Home Theater System User Manual


  Open as PDF
of 68
 
46
On start
Whenthisfunctionissetto“On,”theprojectoris
automaticallyturnedonjustbyconnectingtheACpower
cordtoanoutlet.
Note:
Besuretoturntheprojectoroffproperly(see“TurningOff
theProjector”onpage19).Iftheprojectoristurnedoff
intheincorrectsequence,theOnstartfunctiondoesnot
operateproperly.
Lamp control
Remote control
Thisprojectorprovidestwodifferentremotecontrolcodes;
thefactory-set,initialcode(Code1)andthesecondarycode
(Code2).Thisswitchingfunctionpreventsremotecontrol
interferencewhenseveralprojectorsorvideoequipmentare
operatedatthesametime.
Whentheprojectorisoperatedin“Code2,”boththe
projectorandtheremotecontrolmustbeswitchedto“Code
2.”
To chan�e the code for the projector:
Selecteither“Code1”or“Code2”inthisSettingMenu.
To chan�e the code for the remote control:
PressandholdboththeMENUandIMAGEbuttonstogether
formorethan5seconds.Afterchangingthecode,make
suretheremotecontroloperatesproperly.
Remote control
Pressandhold
MENUand
IMAGEbuttons
formorethan5
seconds.
On start
Note:
•Whendifferentcodesaresetontheprojectorandonthe
remotecontrol,anyoperationcannotbemade.Inthat
case,switchthecodeontheremotecontroltofitthecode
ontheprojector.
•Ifthebatteriesareremovedfromtheremotecontrolfora
longperiodoftime,theremotecontrolcodewillbereset.
Settin�
Note:
Lampmodecannotbechangedforawhileafter
turningontheprojector.Lampneedssometimeto
stabilizeafterthepoweristurnedon.Storedlamp
modewillbeactiveafterthelampisstabilized.
Youcanchangethebrightnessofthescreen.
Normal…Normalbrightness
Eco……Lowerbrightnessreducesthelamppower
consumptionandextendsthelamplife.
 previous next