Filter
Top Products
Recorder connections
02
64
En
2 Use a SCART cable (not supplied) to connect the
AV1 (RGB)-TV
AV connector to a SCART AV connector
on your TV.
This enables you to watch discs.
3 Use another SCART cable to connect the AV2
(INPUT 1/DECODER) AV connector to a SCART AV
connector on your cable box/satellite receiver.
This enables you to record scrambled TV channels.
4 Plug the supplied G-LINK™ cable to the G-LINK™
jack.
This enables you to control the tuner in the external
receiver using the GUIDE Plus+
®
system.
Position the IR transmitter end of the G-LINK™ cable so
that the IR receiver on your cable/satellite receiver will
pick up the control signals (see diagram).
See the manual that came with your cable/satellite
receiver if you’re not sure where the IR receiver is on the
front panel. Alternatively, experiment with the remote
control, operating it from very close range until you find
the place where the receiver responds.
Tip
• This recorder has a ‘through’ function which allows
you to record a TV programme from the built-in TV
tuner in this recorder while watching a video playing
on your VCR (To use this feature when the recorder is
in standby,
Power Save
must be set to
Off
— see
Power Save
on page 152).
Connecting an external decoder box (1)
If you have an external, dedicated decoder box for your
satellite or cable TV system, use the setup described on
this page. See above for how to connect the G-LINK™
cable.
Important
• Do not connect your decoder box directly to this
recorder.
• Information from the decoder (for example, relating
to pay TV services), is only viewable when this
recorder is off (in standby).
• For timer recording to work properly on this recorder,
the VCR/satellite receiver/cable box must also be
switched on during recording.
• It is not possible to watch one TV programme and
record another using this setup.
1 Connect the cable from the antenna/cable TV
outlet to the antenna input on your VCR/satellite
receiver/cable box.
2 Use a SCART cable (not supplied) to connect your
decoder to your VCR/satellite receiver/cable box.
See the manual for your decoder box for more detailed
instructions.
3 Use a SCART cable to connect your VCR/satellite
receiver/cable box to the AV2 (INPUT 1/DECODER)
AV connector on this recorder.
4 Use a SCART cable to connect the AV1 (RGB)-TV
AV connector to your TV.
CONTROL
G-LINK
IN
AV 1 (RGB) – TV
AV 2 (INPUT 1/DECODER)
ANTENNA
IN
OUT
G-LINK cable
AC IN
DIGITAL
AUDIO OUT
COAXIAL
HDMI OUT
ANTENNA(DIGITAL)
IN
OUT
5 V
30 mA
CONTROL
G-LINK
IN
AV 1 (RGB) – TV
AV 2 (INPUT 1/DECODER)
ANTENNA
IN
OUT
TV
Antenna/cable TV
wall outlet
VCR/Satellite receiver
/Cable box
Decoder
1
2
3
4
From SCART AV
connector
To SCART AV
connector
SCART AV
connection
AV2 (INPUT 1/
DECODER)
AV1 (RGB) - TV
To antenna input
02SDVRLX70D_EN.book 64 ページ ２００７年７月１８日 水曜日 午前１０時９分