Filter
Top Products
Additional information
16
169
En
If the unit does not operate normally due to external effects such as static electricity, disconnect the power plug from the
outlet and insert again to return to normal operating conditions.
If the picture freezes and the front panel and remote control buttons stop working
• Press
(Stop) then try restarting playback.
• Press the front panel
STANDBY/ON
button to
switch the power off, then switch back on and restart
playback. If the power fails to switch off, press and
hold
STANDBY/ON
for five seconds until the
power switches off.
HDMI Control does not
respond
• Verify that the HDMI cable is firmly connected (page 65).
• Check whether HDMI Control is set to On for this recorder, the receiver subwoofer and the
device connected to this recorder. For more information, refer to the operating instructions of
your plasma television and
HDMI Control
on page 44.
• Depending on the type of plasma television, some HDMI input terminals do not support the
HDMI Control function. For details, see the operating instructions supplied with your plasma
television.
• If you want to use an HDMI cable other than the supplied HDMI cable, use the one that
supports the HDMI 1.3 specification. The HDMI Control functions may not operate properly if
you do not use an HDMI cable that supports the HDMI 1.3 specification.
• This function may not work properly if you have multiple recorders connected to a single
plasma television or the receiver subwoofer. For more information refer to the operating
instructions of your plasma television and
HDMI Control
on page 44.
• Controls may not function properly in certain situations, such as immediately after you
have connect an HDMI cable, turn this recorder’s power off or remove the power cable for
this recorder or the connected component. If you experience any problems, set HDMI Control
to On for all connected units, and then display the pictures stored on this recorder on your
plasma television to improve the situations.
• Check whether the connected component supports HDMI Control or not.
• Certain functions are not supported on with plasma televisions.
• We cannot guarantee this recorder will work with HDMI Control-compatible components
other than those made by Pioneer. When using HDMI Control-compatible components
manufactured by companies other than Pioneer, set the
HDMI Control
to
Off
(page 159).
Problem
Remedy
STOP RECPLAY
OPEN/
CLOSE
STOP REC
USB
DV IN
STANDBY/ON
STOP
STANDBY/ON
02SDVRLX70D_EN.book 169 ページ ２００７年７月１８日 水曜日 午前１０時９分