Filter
Top Products
Additional information
11
52
En
Displayed Messages
Message
Description
192kHz PCM
SACD
DTS-HD
DTS Express
Dolby TrueHD
Dolby D+
These messages are displayed when you operate a function incompatible with the audio
source being played back.
No MIC
Displays when you press MCACC when the MCACC setup mic is not connected.
Muting
Displays when you press TEST TONE or MCACC while this unit is muted.
2ch Only
An operation is prohibited because it is only applicable to 2 channel sources, while the
current source is a multichannel source.
Exit
Appears when a menu is automatically exited after a set period of inactivity.
HDMI Through
Displays when you change the Listening Mode, the volume level, or some sound settings
when the HDMI Mode is set to Through Mode.
Unknown
The genre information for contents being played back on the HDD/DVD recorder cannot be
obtained.
No Genre
There is no genre set for contents being played back on the HDD/DVD recorder.
HDMI C.ERR 2C*
The connected component is not compatible with synchronized genre mode.
Can’t use
• You tried to use Genre Sync Mode for a source component that does not support this
function.
• The source component is in a situation where Genre Sync Mode cannot be used.
• You tried to use Genre Sync Mode when the input source of this unit is a source other
than HDMI.
• The operation is forbidden due to the surround settings.
• When the volume level is over 51, some functions are restricted.
HDMI C.ERR 1**
Check if the HDMI cable is properly connected. If the cable is properly connected, this unit
may be damaged. In such an event, please contact a Pioneer-authorized service center or
your nearest dealer.
Noisy!
Background noise is too high to complete MCACC setup successfully.
Error MIC!
An error occurred during MCACC setup because the microphone is not connected or is
not connected properly.
Error Speaker!
An error occurred during MCACC setup because the speakers are not connected or are
not connected properly.
Over Temp
Try lowering the volume. If this problem is not fixed by removing and inserting the power
cable, this unit may be damaged. In such an event, please contact a Pioneer-authorized
service center or your nearest dealer.
OC Error1
OC Error2
Check whether the speaker cables are short-circuited. If the error message continues to be
displayed, contact your Pioneer authorized service center or your dealer for servicing.
*** BackUpERR
Contact your Pioneer authorized service center or your dealer for servicing.
01SX-SW70SW_EN.book 52 ページ ２００７年７月１７日 火曜日 午後８時２８分